KitchenAid KEBC149BSS Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Oven KitchenAid KEBC149BSS. KitchenAid KEBC149BSS 16 halaman. 24" (60 cm) electric built-in oven

Halaman Cetak

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrical installer determine that

the ground path and the wire gauge are in accordance with local

codes.

Check with a qualified electrical installer if you are not sure the

oven is properly grounded.

This oven must be connected to a grounded metal, permanent

wiring system.

Be sure that the electrical connection and wire size are adequate

and in conformance with the CSA Standards C22.1-94, Canadian

Electrical Code, Part 1 and C22.2 No. O-M91-latest edition, and

all local codes and ordinances.

A copy of the above code standards can be obtained from:

Canadian Standards Association

178 Rexdale Blvd.

Toronto, ON M9W 1R3 CANADA

Electrical Connection

To properly install your oven, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

Oven must be connected to the proper electrical voltage and

frequency as specified on the model/serial number rating

plate. The model/serial number rating plate is on the right

vertical part of the oven frame. See the following illustration.

A. Model/serial number plate

Prepare Built-In Oven

1. Decide on the final location for the oven. Avoid drilling or

cutting into house wiring during installation.

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven.

Failure to do so can result in back or other injury.

2. To avoid floor damage, set the oven onto cardboard prior to

installation. Do not use handle or any portion of the front

frame for lifting.

3. Remove the shipping materials and tape from the oven.

4. Remove the hardware package from inside the bag

containing literature.

5. Remove and set aside racks and other parts from inside the

oven.

6. Move oven and cardboard close to the oven's final location.

Electrical Requirements

INSTALLATION INSTRUCTIONS

Models rated 3.6 kW and below at 120/240 volts require a

separate 15-amp circuit. Models rated 3.6 to 4.8 kW at

120/240 volts require a separate 20-amp circuit.

A circuit breaker is recommended.

Connect directly to the circuit breaker box (or fused

disconnect) through flexible, armored or nonmetallic

sheathed, copper cable (with grounding wire). See "Make

Electrical Connection" section.

CSA approved flexible conduit from the oven should be

connected directly to the junction box.

Fuse both sides of the line.

Do not cut the conduit. The length of conduit provided is for

serviceability of the oven.

A CSA approved conduit connector must be provided.

If the house has aluminum wiring, follow the procedure

below:

1. Connect a section of solid copper wire to the ends of the

CSA approved flexible conduit leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.

Remove Oven Door

IMPORTANT: Use both hands to remove oven doors.

1. Open oven door all the way.

2. Flip up the hinge latch on each side.

3. Close the oven door as far as it will shut.

4. Lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from

the oven door frame.