Garden Sun GS4400BK Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemanas Teras Garden Sun GS4400BK. Garden Sun GS4400BK 13 halaman.
Halaman Cetak
Troubleshooting
If the problem is:
Pilot won't light
Note:
Heater
operates
reduced efficiency below 40ºF
(5ºC)
Pilot won't stay lit
Burner won't light
Burner flame is low
Carbon build-up
Thick black smoke
Maintenance
WARNING
FOR YOUR SAFETY:
• Do NOT touch or move heater for at least 45 minutes
after use.
• Reflector is hot to the touch.
• Allow reflector to cool before touching.
a. Keeping the appliance area clear and free from combustible
materials , gasoline and other flammable vapors and liquids.
b. Not obstructing the flow of combustion and ventilation air.
And this condition exists:
Cylinder valve is closed
Blockage in orifice or pilot tube
Air in gas line
Low gas pressure with cylinder valve
fully open
at
Igniter fails
Dirt built up around pilot
Connection between gas valve and
pilot assembly is loose
Thermocouple is not operating correctly
Gas pressure is low
Blockage in orifice
Control knob is not in ON position
Gas pressure is low
Outdoor temperature is less than
and tank is less than 1/4 full
Supply hose is bent or kinked
Control knob fully ON
Dirt or film on reflector and burner screen
Blockage in burner
Then do this
Open valve
Clean or replace orifice or pilot tube
Open gas line and bleed it (pressing control
knob in) for not more than 1 - 2 minutes or until
you smell gas
Turn cylinder valve OFF and replace cylinder
Use match to light pilot; obtain new igniter and
replace
Clean dirt from around pilot
Tighten connection and perform leak check
Replace thermocouple
Turn cylinder valve OFF and replace cylinder
Clear blockage
Turn control knob to ON
Turn cylinder valve OFF and replace cylinder
40ºF
Use a full cylinder
Straighten hose
Check burner and orifices for blockage
Clean reflector and burner screen
Remove blockage and clean burner inside and
outside
c.Keeping the ventilation opening(s) of the cylinder enclosure
free and clear from debris.
d. Visually checking burner flames , with pictorial representations.
e. Cleaning the appliance , including special surfaces , with
recommended cleaning agents , if necessary.
f. Lubrication of moving parts and the type and amount of lubricant
to be used.
g. When applicable , visually checking portions of the hose
assembly located within the confines of the heater post.
Air flow must be unobstructed. Keep controls, burner,
and circulating air passageways clean. Signs of possible
blockage include:
11