Jandy ePump Panduan Instalasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pompa Air Jandy ePump. Jandy ePump 16 halaman. Variable speed pump user interface
![Jandy ePump Panduan Instalasi](/uploads/products/server2/2125176/2125176.png)
4.
Connect one side of the ¿ reman's switch to the
ePump™ Controller at J3 REMOTE CONTROL,
COMMON.
5.
Connect the other side of the ¿ reman's switch to the
ePump™ controller at J3 REMOTE CONTROL,
INPUT 4.
6.
Set the timeclock to the desired on/off times.
7.
Turn on all switches and the main breaker feeding
power to the ePump™.
8
If the installation is working properly, the ¿ reman's
switch will open 20 minutes before the booster
pump shuts down, the ePump™ will continue to run
for 30 minutes, and the ePump™ Controller will
display PUMP WILL REMAIN ON FOR XX:XX,
where XX:XX is the time remaining until ePump™
shutdown.
Section 3. User Operation
3.1
OFF Mode
When the pump is off (not running), the controller displays
PRESS PRESET OR MENU/00:00 PUMP IS OFF,
where 00:00 is the time-of-day clock.
PRESS PRESET OR MENU
12:00AM
2
3.2
RUN Mode
When the pump is running (not off), the controller displays
N:LABEL/00:00 RPM:XXXX, where n:label is the number
and label of the selected preset, 00:00 is the time-of-day
clock, and xxxx is the pump speed.
10:00AM
2
PUMP IS OFF
3
4
ePUMP
MENU
2:PRESET 2
RPM: 1200
4
ePUMP
3
MENU
3.3
Manual Start and Stop
Up to eight (8) programmed speeds may be started from the
controller. Manual operation of speeds "eStar" through "4"
differs from manual operation of speeds "5" through "8".
NOTE
When starting the pump, the pump will first run at the
priming speed for the priming duration, as set by the
installer.
3.3.1
Speeds eStar through 4
To start the pump manually running at speeds "eStar" through
"4", press button "
" through "4" corresponding to the
desired speed. The associated LED will light red and the
controller enters the RUN mode.
10:00AM
2
To stop the pump, press the button again. The associated LED
will extinguish and the pump and controller will return to the
OFF mode.
3.3.2
Speeds 5 through 8
To start the pump manually at speeds "5" through "8",
press the MENU button. The controller displays SELECT
PRESET/N:LABEL, where n:label is the number and label
of the last selected preset "5" through "8".
Using the arrow keys, select the desired preset to activate,
and then press MENU to enter RUN mode, starting the pump
running at the selected speed.
SELECT PRESET
2
To stop the pump, press MENU. To exit without starting the
pump, press any button "
3.4
Pump Speed Setting
With the exception of preset "
preset may be adjusted while the pump is running in that
preset mode. Preset "
" is reserved for the eStar function,
and its speed is set by the installer.
Page 9
2:PRESET 2
RPM: 1200
3
4
ePUMP
MENU
5:PRESET 5
3
4
ePUMP
MENU
" through "4".
", the pump speed for each