Jandy Pro VSPHP270JEP Panduan Instalasi dan Pengoperasian - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pompa Air Jandy Pro VSPHP270JEP. Jandy Pro VSPHP270JEP 20 halaman.

Page 16

ENGLISH

Symptom

Variable-Speed

Incorrect dip switch setting.

Controller LCD

Make sure pump dip switches 1 and 2 are both ON if the controller is the JEP-R and both are OFF if the

is not displaying

controller is a PDA, AquaLink RS, or AquaLink Z4. See "3.2.4.1 Install with AquaLink® controller"

information

Improper low-voltage wiring.

pump LEDs are

Check low-voltage wiring between pump and controller. Correct if necessary. See "3.2 Electrical Installation"

not illuminated.

Controller

Improper low-voltage wiring.

displays "Pump

Check low-voltage wiring between pump and controller. Correct if necessary. See "3.2 Electrical Installation"

not connected".

Improper pump address set.

Ensure pump dip switches 3 and 4 are set properly for the installation. Both should be OFF for use with

Variable-Speed Controller or set to the proper address when connected to an AquaLink RS, AquaLink PDA,

or an AquaLink Z4. See "3.2.4.1 Install with AquaLink® controller"

Fault message

Fault condition exists.

appears on

View fault message on controller and correct fault before proceeding. If unsure how to correct fault, contact

controller display.

Zodiac Technical Support at 800.822.7933.

Jandy

Pro Series VS PlusHP Pumps

Possible Cause/Solution

Installation & Operation Manual