Jandy Jandy Pro Series Panduan Instalasi dan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pengontrol Jandy Jandy Pro Series. Jandy Jandy Pro Series 16 halaman. Single element cartridge pool & spa cs filters
Juga untuk Jandy Jandy Pro Series: Panduan Pemilik (12 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi dan Pengoperasian (20 halaman), Panduan Pemilik (20 halaman), Manual (8 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi dan Pengoperasian (20 halaman), Petunjuk Instalasi (2 halaman), Panduan Instalasi dan Pengoperasian (16 halaman), Panduan Instalasi dan Pengoperasian (16 halaman)

Halaman Cetak
Jandy Jandy Pro Series Panduan Instalasi dan Pengoperasian
#12x1" Pan Head
Stainless Steel
Screw (Qty 8)
Anchor
Bracket
(Qty 4)
Filter Tank Anchor Bracket Installation
Figure 3.
Anchor Filter to Equipment Pad
3.4

Filter Plumbing

WARNING
To avoid an electrical shock hazard, which can result
in serious injury or death, ensure that all electrical
power to the system is turned off before approaching,
inspecting or troubleshooting any leaking valves
or plumbing that may have caused other electrical
devices in the surrounding area to get wet.
1.
This filter operates under pressure. When clamped
properly and operated without air in the water
system, this filter will operate in a safe manner.
Heater
Waterfall
Pool Return
Figure 4. Basic Pool/Spa Combination Plumbing
|
Jandy
DE Pool Filters
Installation & Operation Manual
®
1/4" x 2-1/4" S.S. Tapcon
Screw and S.S. Washer
Drill 5/32" Hole
Tank Bottom
Spa Make Up
Check
Valve
#12x1" Stainless Steel Pan
Head Screws (Qty 2)
Drill Two 3/32" Holes
Through Filter Base
Mounting Bracket
®
Anchor Bracket to Platform Installation
2.
If doubt exists as to the pressure which the
system will be subjected to, install an ASME
approved automatic Pressure Relief Valve or
Pressure Regulator in the circulation system
set to the lowest working pressure of any of the
components in the system.
3.
Place the filter on the concrete pad, lined up with
the inlet/outlet pipes, see Figure 4. Remove the
shipping screw.
4.
To mount the pressure gauge/air release assembly
to the top of the filter tank (located in the
accessory bag):
From Outlet Port
Filter
From Pool
Drain
Spa Return
From Pool Skimmer
Page 7
ENGLISH
Filter Base
Mounting Tab
3-1/2" Thick
(Min.)
Concrete Pad
To Inlet Port
Pump
Spa Suction
®