Gardena 34 E basicMove Panduan Petunjuk Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin Pemotong Rumput Gardena 34 E basicMove. Gardena 34 E basicMove 13 halaman. Electric flexible steerable lawnmower
Juga untuk Gardena 34 E basicMove: Panduan Petunjuk Pengoperasian (12 halaman)
The mains voltage and the equipment voltage
stated on the type plate must be the same. If
extension cables are used, these must comply
with the minimum cross-sections in the table
below :
Voltage
220 - 240V/ 50 Hz
220 - 240V/ 50 Hz
3. Assembly
34 E easyMove
Fitting the wheels :
4
Fitting the grass box :
4. Operation
14
Cable
Cross-
length
section
Up to 20 m
1.5 mm
20 - 50 m
2.5 mm
All 4 wheels must always be screwed in at the same cutting
height (see 4 Operation "Setting the cutting height").
1. Insert screw
the 6-sided head fully into the hub cap
Insert the short screw in the small hub cap and the large
2
1
3
screw in the large hub cap.
2. Press covering cap
place.
3. Insert screw
firmly in place by hand at the side and ensure it is securely
located. Screw in the small wheels (13 cm diameter) at the front
and the large wheels (16 cm diameter) at the rear.
1. Place the box cover
a way that ALL the eyes
7
2. Press the box cover
engage securely.
c
3. Inspect: Check that all the hooks
d
8
DANGER !
A
Cutting tool can cause injuries !
V Wait until the cutting tool is stationary before
A brief voltage dip may occur when you switch
on your shredder (due to conditions of the
power supply) that may affect other devices
(e.g. a lamp may flicker).
This problem should not occur with supply
impedances of Z
2
2
1
through the bore in the hub cap
3
into the hub cap
1
through the wheel
7
on the grass box
c
are positioned over the hooks
7
on to the grass box
undertaking any adjustment work, wear suitable
work gloves and pull out the mains plug.
< 0,46 Ohm.
max
2
and push
2
.
2
until it snaps in
4
and screw the wheel
8
from above in such
8
until the hooks
d
are engaged securely.
4
d
.
d