Gardena 38 E easyMove Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin Pemotong Rumput Gardena 38 E easyMove. Gardena 38 E easyMove 13 halaman. Electric flexible steerable lawnmower

Gardena 38 E easyMove Panduan Petunjuk Pengoperasian
Fault
Motor will not start
Motor jammed and making
a noise
Loud noises, mower
rattling
Runs unevenly, mower
vibrates strongly
Lawn is not cleanly cut
38 E: level indicator shows
full although the grass box
is not full yet
If any other faults occur, please contact GARDENA Service.
Possible cause
Power supply cable faulty.
Extension cable may not have a
large enough cross-section.
Jammed with foreign body.
Cutting height too low for the
lawn or mowing speed too high.
Screws on motor, its fixing or on v Have screws tightened by an
the mower casing loose.
Blade damaged or blade
mounting released from motor
shaft.
Out of balance because of
very dirty blade.
Blade blunt.
Cutting height too low.
Mowing speed too high.
Level indicator is dirty.
Please contact GARDENA Service before sending the
mower. Repairs may only be carried out by GARDENA
service centres or dealers authorised by GARDENA.
Remedy
vCheck power supply cable.
v Use extension cable with
cross-section complying with
table (2. For your Safety).
v Switch off motor, pull out
mains plug and remove
foreign body.
v Raise cutting height or
or reduce mowing speed.
authorised specialist dealer
or GARDENA-Service.
v Have blade tightened or
replaced by an authorised
specialist dealer or
GARDENA-Service.
v Clean mower (see
6. Maintenance). If this
does not rectify the fault,
contact GARDENA Service.
v Have blade replaced.
v Increase cutting height.
v Reduce mowing speed.
v Clean level indicator (see
6. Maintenance).
19