Gardena 5039 Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Mesin Pemotong Rumput Gardena 5039. Gardena 5039 17 halaman. Battery lawnmower
Juga untuk Gardena 5039: Panduan Operator (17 halaman), Panduan Operator (11 halaman), Panduan Operator (17 halaman), Panduan Operator (18 halaman)

Gardena 5039 Panduan Operator
Problem
Mower does not start
Engine is jammed and
makes a noise
Loud noises, the mower
is rattling
Mower runs unevenly or
vibrates strongly
Lawn is not cleanly mowed
¥
Error-LED
on the battery
flashes
2,6Ah
¥
¥
Error-LED
on the battery
illuminates
Charging control lamp
on the charger does not
illuminate
å
The GARDENA spare parts are available from your GARDENA dealer
or from the GARDENA service.
Only use an original GARDENA blade:
• GARDENA replacement blade Art. 4100.
v Let the blade be replaced by the GARDENA Service or a specialist
dealer authorised by GARDENA.
Possible Cause
Battery is not put completely
into the battery holder.
On LED is off.
Safety key is not in positon 1.
Blade is blocked.
Blade is blocked.
Cutting height is too low.
Screws on engine, its fixing or
on the mower housing are loose.
Blade is damaged / worn or the
blade mounting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
Battery overload.
Under voltage.
Battery temperature is out of
range.
Battery error / battery defective.
å
Battery charger or charging cable
are not connected correctly.
Remedy
v Put the battery completely into
the battery holder until it audibly
engages.
v Push the On/Off button.
v Turn the safety key to
position 1.
v Remove the obstacle.
v Remove the obstacle.
v Raise the cutting height.
v Let the screws be tightened by
an authorised specialist dealer
or the GARDENA Service.
v Let the blade be tightened
or replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower
(see 4. MAINTENANCE). If this
does not rectify the problem,
contact the GARDENA Service.
v Let the blade be replaced by
the GARDENA Service.
v Raise the cutting height.
v Release the start levers.
Start again.
v Charge the battery.
v Use the battery in surround-
ings where temperatures are
between – 10 °C and 40 °C.
v Contact the GARDENA Service.
v Connect the battery charger
and charging cable correctly.
23