Gardena smart SILENO city Panduan Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Mesin Pemotong Rumput Gardena smart SILENO city. Gardena smart SILENO city 4 halaman.
Juga untuk Gardena smart SILENO city: Panduan Cepat (4 halaman), Panduan Cepat (4 halaman)

Halaman Cetak

3. Connecting the boundary wire

See chapter 3.6 in the supplied operator's manual or on the

GARDENA website (www.gardena.com).

1. Open the connector and lay the boundary wire in the connector.

2. Press the connector and the wire together by using a pair of pliers.

3. Cut off any surplus boundary wire. Cut off the wire 1 to 2 cm after the connectors.

4. Press the boundary wire connectors onto the contact pins marked L (left) and R (right)

on the charging station.

NOTE: The right-hand wire must be connected to the right-hand contact pin on the

charging station, and the left-hand wire to the left-hand pin.

5. Mark the wires with the accompanying cable markers. This makes it easier to reconnect

the wires correctly.

4. Laying and connecting the guide wire

See chapter 3.7 in the supplied operator's manual or on the

GARDENA website (www.gardena.com).

1. Push the guide wire through the slot in the bottom of the charger station.

2. Fit the connector to the guide wire in the same way as for the boundary wire,

according to the instructions above.

3. Press the guide wire connector onto the contact pin marked Guide on the charging

station.

4. Pull the guide wire a minimum of 1 meter straight out from the front edge of the

charging station.

5. Lay the guide wire from the charging station to the point on the boundary wire

(eyelet) where the connection is made.

NOTE: Do not lay the guide wire at an acute angle.

6. Cut the boundary wire at the centre of the eyelet that was made in step 2.2.

7. Connect the guide wire to the boundary wire by inserting the boundary wires and

guide wire in the coupler, and pressing the coupler together with a multi-grip

pliers.

„As a complement to this Quick Guide. There are step by step

installation movies available on the GARDENA website,

www.gardena.com."

Power supply

(the appearance of the power supply

may differ depending on market)

P01 QG_EN_3.indd 3

Low voltage cable

Boundary wire and

couplers

Pegs

Connectors

min 1 m / 3.3 ft

Measurement

gauge

2017-12-14 13:46:09