Brizo EP103441 Petunjuk Manual - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pembicara Brizo EP103441. Brizo EP103441 8 halaman. Audio module and invisible speakers

Halaman Cetak

Audio Module Installation

Instalación del módulo de audio

Installation du module audio

• Select a location for mounting the audio module in a utility area or closet. The audio input jacks on the side of the module should be conveniently

accessible to plug in additional audio inputs. Secure to the wall with screws. Do not install any part of this assembly inside a wall.

• Make sure a 120 volt outlet is located near the module mounting location. Plug in the 5' power cord (supplied) after all connections are complete.

• Route the control cable from the module location to the 8GE-TSG series steam generator, or optional R80000E, 8SP-MU-4 and/or 8SP-MU-5.

The manners in which the cables are routed are dependent on what is best suited for the installation. There are multiple connection jacks in 8GE-

TSG series steam generator, two in the 8SP-MU-5, two in the R80000E, two in the 8SP-MU-4, and two on this module allowing for gangable

connections in the most convenient arrangement (See figure 3 for the system wiring diagram).

• Indicator lights, (See Figure 1):

Green Light (Power Light): This along with the blue and yellow light will flash momentarily when the power is first plugged in. This flash

indicates the microprocessor is functioning and is a test for the lights.

Yellow Light (Communication Light): This light is an indicator that the system is not communicating with the control. After the initial power

up the light will continue to flash until communication is established with the 8CH-600, 8CB-600 or 8CN-600 series control. To establish

communication, power to the 8CH-600, 8CB-600 or 8CN-600 series control must be turned on. If power is already on go to the 8CH-600,

8CB-600 or 8CN-600 series control and start a steam or shower cycle for a few seconds. Then stop or cancel the cycle. This action will

make the 8CH-600, 8CB-600 or 8CN-600 series control look for the audio system and establish communication. When the audio module is

communicating with the 8CH-600, 8CB-600 or 8CN-600 series control this light will be off.

Blue Light (Bluetooth Light): This light will be on steady when the bluetooth signal is broadcasting and not paired with a device. When a

device is paired the light will flash. The light will turn off if bluetooth is turned off on the 8CH-600, 8CB-600 or 8CN-600 series control.

• Refer to the wiring diagram on (Figure 3) for connecting the speakers to the audio control module or invisible speakers.

To reduce the risk of electric shock, do not perform any servicing other

then that contained in the operating instructions unless you are qualified

to do so.

Figure 1

Side View/Vista lateral/Vue latérale

Bluetooth antenna

Antena bluetooth

Antenne Bluetooth

Indicator lights

Luces indicadoras

Voyants

Yellow

Green

Blue

Speaker connections

Conexiones de altavoces

Connexions des haut-

parleurs

Power cord

Cable de alimentación

Cordon d'alimentation

CAUTION

Control cable connections

Conexiones para cables de

control

Connexions du câble de

l'appareil de commande

Audio "A" input

Entrada de audio "A"

Entrée audio « A »

Audio "B" input

Entrada de audio "B"

Entrée audio « B »

Right +/Derecha +/Droit +

Right -/Derecha -Droit -

Left -/Izquierda -/Gauche -

Left +/Izquierda +/Gauche +

113380 Rev. F