Lexmark CS431dw Referensi Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Referensi Cepat untuk Printer Lexmark CS431dw. Lexmark CS431dw 11 halaman.
Before you begin, make sure that:
•
Active Adapter is set to Auto. From the control panel, navigate
to:
Settings > Network/Ports > Network Overview > Active
Adapter
For non-touch-screen printer models, press
through the settings.
•
The Ethernet cable is not connected to the printer.
Using the wireless setup wizard in the printer
Notes:
•
These instructions apply only to some printer models.
•
Before using the wizard, make sure that the printer firmware
is updated. For more information, see
"Updating firmware"
on page
5.
1
From the home screen, touch
> Set up now.
Select a Wi ‑ Fi network, and then type the network password.
2
3
Touch Done.
1
From the control panel, navigate to:
Settings > Network/Ports > Wireless > Setup On Printer Panel
For non-touch-screen printer models, press
through the settings.
Select a Wi ‑ Fi network, and then type the network password.
2
Note: For Wi ‑ Fi ‑ network ‑ ready printer models, a prompt to
set up the Wi ‑ Fi network appears during initial setup.
Clearing jams
Avoiding jams
Load paper properly
•
Make sure that the paper lies flat in the tray.
Correct loading of paper
to navigate
•
Do not load or remove a tray while the printer is printing.
•
Do not load too much paper. Make sure that the stack height
is below the maximum paper fill indicator.
•
Do not slide paper into the tray. Load paper as shown in the
illustration.
to navigate
•
Make sure that the paper guides are positioned correctly and
are not pressing tightly against the paper or envelopes.
•
Push the tray firmly into the printer after loading paper.
Use recommended paper
•
Use only recommended paper or specialty media.
•
Do not load paper that is wrinkled, creased, damp, bent, or
curled.
Incorrect loading of paper
6
•
Flex, fan, and align the paper edges before loading.
•
Do not use paper that has been cut or trimmed by hand.
•
Do not mix paper sizes, weights, or types in the same tray.
•
Make sure that the paper size and type are set correctly on the
computer or printer control panel.
•
Store paper according to manufacturer recommendations.
Identifying jam locations
Notes:
•
When Jam Assist is set to On, the printer might attempt to
flush blank pages or pages with partial prints after a jammed
page has been cleared. Check your printed output for blank
pages.
•
When Jam Recovery is set to On or Auto, the printer reprints
jammed pages.