Gardena 6500 SP Panduan Petunjuk Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pompa Air Gardena 6500 SP. Gardena 6500 SP 10 halaman. Dirty water pump
Halaman Cetak
Notes on use
Thermal motor protector
Automatic deaerating
valve
3. Initial Operation
Hose diameter
a
b
7
Hose connection
7
of universal fitting
Hose connection
v Clear the outlet line before use.
Dry-running operation causes increased wear and is to be
avoided. Therefore, in manual operation the pump must be
immediately unplugged when water fails to flow.
Avoid running of the pump for more than 10 min. against closed
delivery side of the pump.
Take care that the pump is located where the inlet openings at
the suction base are obstructed neither completely nor partly.
Stand the pump on a brick if using in a pond.
The pump is automatically switched off on overheating by
the built-in thermal motor protector. After having cooled down,
the motor automatically switches on again (see 6. Trouble
Shooting).
The automatic deaerating valve eliminates any air pockets in
the pump. During this process, air escapes through the vent
4
bores
and air bubbles appear underwater. This is not a defect
of your pump, but serves to deaerate the pump.
It may take several seconds for the air to escape when the
4
pump is immersed for the first time.
13 mm (1/ 2 ")
15 mm (5 / 8")
19 mm (3 /4")
Cut off topmost
a
nipple at
The following connection kits are required for 13 mm to 19 mm
connections:
13 mm (1/ 2 "): GARDENA Pump Connection Set, Art. No. 1750
15 mm (5/ 8 "): GARDENA Tap Connector, Art. No. (2)902, and
19 mm (3 /4 "): GARDENA Pump Connection Set, Art. No. 1752
Best results in delivery capacity are achieved when using
38 mm (1 1/ 2 ") hoses.
25 mm (1")
Do not cut off
.
any nipples.
Standard Hose Connector, Art. No. (2)916
38 mm (1 1/2 ")
Cut off top two
b
nipples at
.
13