Corventis zLink Petunjuk Penggunaan Manual - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Peralatan Medis Corventis zLink. Corventis zLink 5 halaman. Mobile patient management system
No specific training is needed for the use of this system.
zLink should be set-up first prior to PiiX application.
1.
Plug the zLink into a standard electrical outlet.
2.
Dock zLink into the Base. The lights will automatically come on, confirming zLink is ON.
Power Light:
BLUE Light ON: Full charge confirmed
AMBER Light ON: Low charge warning
AMBER Light Flashing: Battery capacity less than 10%. Full charge may take up to 4 hours
Cell Light:
BLUE: Adequate cell coverage
AMBER: No cell coverage. Move zLink to another location
Other lights on the zLink are utilized only if troubleshooting is necessary. Refer to these lights only if asked by a Corventis Customer
Service representative.
zLink may also be turned ON and OFF manually. To turn zLink ON when zLink is not docked in the Base, press the round Power button
located below the lights. All lights will come on, confirming zLink is ON. To turn zLink OFF, press the round Power button for several
seconds until all the lights turn off.
3.
To initiate use, charge the zLink for a minimum of 4 hours before removing it from the zLink Base
Keep your zLink in the Base overnight, every night. With a full charge, the zLink will remain charged for up to 12 hours. Preferably, the zLink
should be kept within 30 feet (9 meters) of the patient as much as possible to ensure data transmission.
First device:
1.
Trim (rather than shave) hair in intended location. Avoid moles and pimples.
2.
Use alcohol wipe provided with PiiX to clean the skin where the device is intended to be applied. Allow the skin to dry.
3.
Remove the PiiX from the foil pouch by tearing at the notch and apply immediately.
4.
Remove the covers from the underside of the PiiX.
© Corventis 2010
For US distribution (01/10)
Step-by-step Operating Instructions – AVIVO Mobile Patient Management System
zLink Set-up
PiiX Application
PiiX
Page 2 of 5