Broadata LBC-H-T-LPB-Lite Petunjuk Keselamatan - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Keselamatan untuk Pemancar Broadata LBC-H-T-LPB-Lite. Broadata LBC-H-T-LPB-Lite 14 halaman. Link bridge hdbaset hdmi transmitter with loopback video

Halaman Cetak

Link Bridge

2.2 Rear Panel

POWER

DC 24V

1. POWER LED:

will illuminate.

2. DC 24V: Plug the 24V DC power supply into the unit and

connect the adaptor to an AC outlet.

3. IR 1 BLASTER: Connect with the supplied IR Blaster to blast

out the IR signal received from the Receiver side. Place the IR

Blaster in direct line- of-sight of the equipment to be controlled.

4. IR 2 EXTENDER: Connect with the supplied IR Extender to

receive IR signal from Transmitter side and blast out at Receiver

side. Ensure that remote controller being used is within the

direct line-of-sight of the IR Extender.

5. USB: This slot is reserved for firmware update only.

6 . LINK LED: This LED will illuminate when both the input source

and output display signals are connected through CAT cable.

When it blinks regularly it states the display is NOT sending

signals to Receiver but the Transmitter and Receiver are linked

and if it blink irregularly it states an error has occurred.

7. CAT-5e/6/7 OUT: Connect this port to CAT5e/6/7 to HDMI

Receiver with CAT-5e/6/7 cable to extend the signal up to 60m.

Broadata Technical Support, [email protected]

HDBaseT HDMI Transmitter w/Loopback Video

IR 1

BLASTER

USB

IR 2

EXTENDER

Once the power supply is connected the LED

LBC-H-T-LPB-Lite User Manual

LINK

CAT5e/6 OUT