Broadata LBC-HDBT2-T/R-48 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemancar Broadata LBC-HDBT2-T/R-48. Broadata LBC-HDBT2-T/R-48 16 halaman. Link bridge hdbaset 2.0 hdmi transmission with 48v poh over 100m

Halaman Cetak

LBC-HDBT2-T/R-48 User Manual

Link Bridge

HDBaseT HDMI 2.0 Transmission w/48V PoH over 100m

2.3 Receiver Front Panel

POWER AUDIO OUT IR IN1 IR OUT2

1. POWER LED: This LED will illuminate when device is connected

with power supply.

2. AUDIO OUT L/R: Connect to speaker with RCA input

for audio signal output.

3. IR IN 1: Connect to the supplied IR Extender cable for IR

signal reception. Ensure that remote being used is within the

direct line-of-sight of the IR Extender.

4. IR OUT 2: Connect to the supplied IR Blaster cable for

IR signal transmission. Place the IR Blaster in direct

line-of-sight of the equipment to be controlled.

5. USB: Connect to USB peripheral devices such as printer,

keyboard, flash driver or ...etc. for data receiving or sending

back to Transmitter.

6. RS-232 OUT TX/RX: Connect to the device that is to be

controlled via 3-pin Relay cable by RS-232 commands. For

sending command to Transmitter side, the TX and Rx pin must

be reversed.

7. UPDATE: This is reserved for firmware update use only. Switch

this deep switch to left for firmware update use, under normal

operation, leave the switch on right. Update procedure may be

done from the same RS-232 port for both Transmitter and

Receiver.

USB

Broadata Technical Support, (800) 214-0222

USB

RS-232 OUT

UPDATE

