Gardena EasyCut Li-14/40 Panduan Operator - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemangkas Gardena EasyCut Li-14/40. Gardena EasyCut Li-14/40 9 halaman. Battery hedge trimmer
Juga untuk Gardena EasyCut Li-14/40: Panduan Operator (9 halaman), Panduan Operator (9 halaman)
Halaman Cetak
1. SAFETY
IMPORTANT!
Read the operator's manual carefully before use and keep for future
reference.
Symbols on the product:
Read operator's manual.
Always wear approved hearing protection.
Always wear approved eye protection.
Danger – Keep hands away from blade.
Do not expose to rain.
For the charger:
Remove plug from the mains immediately if the cable
is damaged or cut.
General safety warnings
General power tool safety warnings:
WARNING!
Read all safety warnings and all instructions! Failure to follow the warnings
and instructions may result in electric shock, fire and / or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains operated (corded)
power tool or battery operated (cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
2) Electrical safety
a) Power tool plugs must match the outlet. Never modify the plug in any
way. Do not use any adaptor plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep cord away from heat, oil, sharp
edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord suitable
for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use
a residual current device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
3) Personal safety
a) Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are tired or
under the influence of drugs, alcohol or medication. A moment of inat-
tention while operating power tools may result in serious personal injury.
b) Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard hat,
or hearing protection used for appropriate conditions will reduce personal
injuries.
c) Prevent unintentional starting. Ensure the switch is in the offposition
before connecting to power source and /or battery pack, picking up or
carrying the tool. Carrying power tools with your finger on the switch or
energising power tools that have the switch on invites accidents.
d) Remove any adjusting key or wrench before turning the power tool on.
A wrench or a key left attached to a rotating part of the power tools may result
in personal injury.
e) Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your
hair, clothing and gloves away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
8
g) If devices are provided for the connection of dust extraction and
collection facilities, ensure these are connected and properly used.
Use of dust collection can reduce dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the correct power tool for your
application. The correct power tool will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and
must be repaired.
c) Disconnect the plug from the power source and /or the battery pack
from the power tool before making any adjustments, changing acces
sories, or storing power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to oper
ate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and
the work to be performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may create a risk of fire
when used with another battery pack.
b) Use power tools only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or other small
metal objects, that can make a connection from one terminal to
another. Shorting the battery terminals together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery;
avoid contact. If contact accidentally occurs, flush with water.
If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
6) Service
Have your power tool serviced by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Hedge trimmer safety warnings:
– Keep all parts of the body away from the cutter blade. Do not remove
cut material or hold material to be cut when blades are moving.
Make sure the switch is off when clearing jammed material.
A moment of inattention while operating the hedge trimmer may result in
serious personal injury.
– Carry the hedge trimmer by the handle with the cutter blade stopped.
When transporting or storing the hedge trimmer always fit the cutting
device cover. Proper handling of the hedge trimmer will reduce possible
personal injury from the cutter blades.
– Hold the power tool by insulated gripping surfaces only, because the
cutter blade may contact hidden wiring or its own cord.
Cutter blades contacting a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electric shock.
– Keep cable away from the cutting area. During operation the cable may
be hidden in shrubs and can be accidentally cut by the blade.
Additional safety warnings
Battery safety
DANGER! Fire risk!
The battery product to be charged must be placed on a nonflammable,
heat resistant and nonconductive surface while charging.
The battery must not be charged unattended.
Keep corrosive, flammable and easily combustible objects clear of the
battery charger and the battery product.
Do not cover the battery charger and the battery product while charging.
Disconnect the battery charger immediately in the event of smoke formation or
fire.
Only use the original GARDENA Charger to charge the battery. The use of other
battery chargers may damage the batteries irreparably and even cause a fire.
Do not use the GARDENA charger to charge external rechargeable batteries,
as GARDENA cannot guarantee compatibility and could therefore present a risk
of fire or explosion.