Gardena 1892 Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Rumput dan Taman Gardena 1892. Gardena 1892 19 halaman. Water control
Juga untuk Gardena 1892: Panduan Operator (18 halaman), Panduan Operator (19 halaman)

Halaman Cetak

7. TROUBLESHOOTING

Problem

No display appears

Manual watering is

not possible using the

button

Watering program is

not being undertaken

(no watering)

Possible Cause

Sleep mode is activated 5 minutes

after the last entry is made to save

energy.

Battery is inserted incorrectly.

Battery is flat.

Temperature on the display is higher

than 70 °C.

Low battery is continuously displayed.

Tap is turned off.

Controller is not connected.

Minimum pressure of 0.5 bar not

available.

Program entry / modification during or

just before the start pulse.

Valve was opened manually previously. v Avoid possible program overlaps.

Tap is turned off.

Soil moisture or rain sensor registers

damp.

Controller is not connected.

Remedy

v To reactivate the display, press

any function button.

v Check the polarity markings

match (+ / –).

v Insert a new (alkaline) battery.

v Display appears after the

temperature has dropped.

v Insert a new (alkaline) battery.

v Turn the tap on.

v Mount the controller on housing.

v Ensure a pressure of at least

0.5 bar and run the program again.

v Make program entry / modification

outside the programmed start

times.

v Turn the tap on.

v If dry, check the setting / location

of the soil moisture / rain sensor.

v Mount the controller on housing.