Avaya 9110 Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Telepon Avaya 9110. Avaya 9110 11 halaman. Remote gateway

Installing the Remote Gateway 911x unit

To install the Remote Gateway 911x unit on a desk, attach the rubber feet to the

bottom and continue with

unit to the network" on page

wall, refer to the Remote Gateway 911x Series Installation and Administration

Guide (555-8421-220).

Connecting the Avaya Remote Gateway 911x series unit to

the network

To route calls over the IP network, or administer the Avaya Remote Gateway

911x series unit from another location on the IP network, connect the unit to the

Ethernet network by doing the following:

To connect the Remote Gateway 911x series unit to the analog line:

Close and latch the ferrite bead.

Note: You may need to adjust the cable loops to make them as tight as

possible.

Plug one end of a 10BaseT Ethernet cable (with an RJ-45 connector) to the

ETHERNET jack on the Remote Gateway 911x series unit.

Note: You must supply your own 10BaseT Ethernet cable with RJ-45

connectors. Contact your system administrator for the correct cable.

Plug the other end of the 10BaseT Ethernet cable to either an Ethernet hub or

network router.

Plug the RJ-11 cable into the 911x unit LINE connector.

Plug the other end of the cable into the analog line jack.

Avaya Remote GatewayInstallation

"Connecting the Avaya Remote Gateway 911x series

7. To install the Remote Gateway 911x unit on the

Avaya Remote Gateway 911x Series Quick Start Guide