Gardena ES 450/30 4060 Panduan Petunjuk Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Rumput dan Taman Gardena ES 450/30 4060. Gardena ES 450/30 4060 8 halaman. Electric lawn scarifier
Halaman Cetak
To prevent tripping, take par-
This helps the areas of lawn
ticular care when moving
which were replaced by moss
backwards and when pulling
to regenerate more quickly.
the scarifier.
5. After using the scarifier, dis-
3. When turning the scarifier, al-
connect the mains plug, re-
ways turn the cable strain relief
move the grass etc. from the
8
device
on the guide handle
wheels and clean the aerator
to the side you are working
cylinder.
on. This makes it considerably
Important ! Do not rinse the
easier to guide the cable.
scarifier with water.
4. When aerating areas of very
Note: To prevent injury,
A
mossy lawn we recommend
wear protective gloves!
re-sowing the lawn after aerat-
ing.
7. Maintenance, Care and Storage
7.1 Adjusting the Aerator
Tip : Adjusting the aerator with-
(Fig. E / E 1)
out visible wear of springs could
Like every technical unit the Lawn
damage the aerator.
Scarifier has wear by using. The
If the aerator is worn it can be
more intensive use the bigger
adjusted as follows:
will be natural abrasion. Hard and
1. Turn off the scarifier, remove
heavy soils accelerate wear also
the mains plug from the
like over-proportional use of the
socket and wait until the
scarifier, e.g. by lending it often
aerator has stopped turning.
or improper handling.
Keep your hands and feet
If the results of your work with
away from the rotating parts.
the aerator become increasingly
2. Press the retaining spring
worse the aerator can be adjust-
together and pull out the ad-
ed up to two steps lower. If the
justment unit
springs have worn down to the
hand side of the aerator in
bend (Fig. E 1) we recommend
the direction of movement
you exchange the aerator as
(i.e. on the right hand side
described in "Exchanging the
when standing behind the
Aerator".
aerator) approx. 6 mm.
3. Turn the adjustment unit
Adjusting Positions
until the next highest number
of the Aerator
is in the 12 o'clock position.
The aerator has the following
4. Re-attach the wheel to the axle
adjusting positions:
by pressing the middle of the
Position 1
adjustment unit
Position set at the factory
retaining spring
audible snap-in. The wheel is
Position 2
now re-attached to the axle.
First adjustment position after
Note : If necessary remove
wear (aerator lowered by 5 mm)
all dirt and contamination from
Position 3
the recesses.
Second adjustment position
5. Repeat points 1- 4 with the
after wear (aerator lowered by a
adjustment unit
further 5 mm)
hand side of the aerator in
the direction of movement
Adjusting the Position (Fig. E)
(i.e. on the left hand side when
C
The adjusting unit
in the
standing behind the aerator).
centre of the wheels is optimally
Important ! This time you
factory pre-set (position 1).
must turn the adjustment unit
14
6.2 Transport
Important ! Switch off the
motor, remove the mains plug
from the socket and wait until
the tool has stopped moving.
When moving the scarifier over
sensitive surfaces, e.g. tiles,
we recommend you carry the
scarifier.
Warning ! The aerator does
A
not stop immediately after
the motor has been turned off.
Danger of injury due to spring
prongs.
C
in an anticlockwise direc-
tion.
Important information :
The aerator must be set to the
same number on both sides.
7.2 Exchanging the Aerator
(Fig. F)
After you have adjusted the
aerator twice (lowered twice)
the aerator cylinder must be ex-
G
changed. A new aerator cylinder
is available from GARDENA
C
on the right
Service, Art. No. 4097.
Warning ! Danger of in-
A
jury due to spring prongs.
Wear protective gloves.
Change the aerator as follows:
C
1. Turn off the scarifier, remove
the mains plug from the
socket and wait until the
aerator has stopped rotating.
2. Turn the scarifier over so the
C
until the
aerator cylinder is facing up-
G
provides an
wards (Fig. F).
3. Loosen the two screws
D
of the end plate
using a
Phillips screw driver (Fig. F).
4. Lift the wheel with the end
D
plate
diagonally until you
can remove the aerator from
C
I
on the left
the square bar
of the drive
shaft (Fig. F 1).
E
5. Remove the aerator
tilting and pulling it from the
receptacle square bar of the
I
drive shaft
(Fig. F 2).
G
6. Insert the new aerator with
the square bar hole on the
I
receptacle square bar
7. Replace the wheel with end
D
plate
on the mount of the
aerator cylinder and secure
with the two screws
F
.
8. Set the adjustment unit
to 1 as described in "Adjusting
the Position".
Note : Ensure that the parts are
not under stress when installed
and that the screws in the end
plate are not overturned.
8. Advice for Proper Use / Safety Instructions
Checks before each
A
Operation
Inspect the unit before each
use. Do not use the Electric
Lawn Scarifier if safety devices
(starting lever; safety cover)
are damaged or worn. Never
operate the unit with the safety
devices by-passed or missing.
Note : Ensure that all nuts, bolts
and screws are tight and that
the scarifier is in good working
order. For safety reasons, allow
all worn out and damaged parts
to be exchanged by GARDENA
Service or authorised specialist
dealers.
Inspect the area to be aerated
before beginning work.
Remove any foreign objects
(e.g. stones) from the area.
Check the working area for
foreign objects (e.g. stones,
branches) during work.
Proper Use /
F
A
Responsibility
This Electric Lawn Scarifier
can cause serious injuries !
You are responsible for the
safety of the working area.
Only use the Electric Lawn
Scarifier for the purposes
by
specified in these instructions.
Only work when visibility is
good.
7.3 Care
Warning : Always discon-
.
A
nect the mains plug be-
fore working on the scarifier !
Clean the wheels of the scarifier
immediately after you have used
C
it to remove grass etc.
Important ! Do not rinse the
scarifier with water.
Also remove grass etc. from the
aerator cylinder.
Familiarise yourself with the
surroundings of your work-
ing area. Check for possible
risks which might be not
audible due to the noise of
the machine.
Wear sturdy shoes and long
trousers to protect your legs.
Keep fingers and feet away
from the aerator cylinder.
Danger of injury !
Make sure that there are no
other people (especially chil-
dren) or animals anywhere
near the working area.
Always push the scarifier at
a walking pace.
Ensure that you have a secure
foothold when working. The
cable should always be kept
away from the aerating area.
Attention! Take extra care when
walking backwards. You may
stumble !
If, in spite of this, you contact
any obstruction when cutting,
turn off the Electric Lawn
Scarifier and remove the ob-
struction. Check the unit for
damage and have it repaired
if necessary.
A
Interruptions of Work
Never leave the Electric Lawn
Scarifier unattended at the
working area.
G
Important : To prevent damag-
ing the scarifier, do not use
hard or sharp objects to re-
move the grass.
Note : Mixed with cooling air that
was taken in, the air inlets may
collect dirt. Therefore remove all
dirt from the air inlets before put-
ting into operation.
7.4 Storage
Always store the scarifier in a
closed room.
If you interrupt your work
store the unit in a safe place.
Disconnect the mains plug !
When you interrupt work in
order to go to another working
area, always switch off the
Electric Lawn Scarifier during
transport.
A
Check the Environment
Never use the unit when it is
raining or in damp or wet areas.
Do not operate your Electric
Lawn Scarifier near swimming
pools or garden ponds.
Please observe the prescribed
local quiet times.
A
Electric Safety
Keep the mains cable away
from the aerator !
Check the power cable re-
gularly for damage and signs
of wear and tear.
The Electric Lawn Scarifier
must only be operated with un-
damaged electric cable. If the
electric cable or the extension
cable is damaged disconnect
the mains plug immediately.
The socket of an extension
cable should be water-proof
or the connection sockets
for extension cables must be
15