Avaya CALLMASTER V Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon Avaya CALLMASTER V. Avaya CALLMASTER V 19 halaman. Avaya telephone console user's guide

Desktop Installation

Note: You can use the telephone without the desktop stand, if you so
choose.
If you do not use the telephone with attached desktop stand, it is
suggested that you place small round feet (available in kit for 3
telephones PEC 33106) on each corner of the bottom of the telephone
housing.
1. Turn the telephone face down on a flat surface.
2. Remove the desktop stand (the upper tabs on the stand are shown as
2 in Figure 4; the lower tab slots are shown as 6 in Figure 4). Also see
Figure 5 which shows removing the desktop stand.
3. Snap one end of the line cord into the "LINE" jack (4 in Figure 4) on the
bottom of the telephone.
4. Connect the expansion module by snapping one end of the expansion
module cord into the "XM24" jack on the back of the telephone (3 in
Figure 4).
5. Thread the line cord (and expansion module cord, if appropriate)
through the routing channel leading to the top of the desktop stand
(1 in Figure 4). Make sure that the line cord is placed securely under
the square tab (7 in Figure 4) to the left of the "LINE" jack and that the
line cord (and the expansion module cord, if appropriate) is also placed
under the square tabs in the routing channel.
Note: If you are using an auxiliary power supply such as the 1151A1
or 1151A2 Power Unit, plug the line cord into the "PHONE" jack
on the auxiliary power supply.
6. Turn the telephone right side up, with the front facing you.
7. Plug the quick-disconnect (QD) connector on the headset into the
QD connector on the headset cord already plugged into one of the
Headset jacks (5 in Figure 4) on the back of your telephone.
8. If appropriate, snap the free end of the expansion module cord into the
TEL SET jack on the expansion module.
9. Snap the free end of the line cord into the modular wall jack.
Note: If you are using an auxiliary power supply such as an 1151A1 or
1151A2 Power Unit, plug the power supply cord from the power
unit's "LINE" jack into the modular wall jack.
10. Turn on the headset OR press
tone. If there is no dial tone, check all wire connections to make sure
they are secure.
(or
Spkr
11
)
and listen for dial