Avaya Definity 6221 Referensi Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Referensi Cepat untuk Telepon Avaya Definity 6221. Avaya Definity 6221 8 halaman. Avaya definity 6219: quick reference
Halaman Cetak—— INSTALLATION ——
TABLE/DESK INSTALLATION
Use the 14-foot straight line cord that came with your
telephone to connect the telephone to a modular jack.
!
WARNING:
Do not plug the handset cord into the line jack or the data
jack on your telephone since it could damage your handset
and the telephone.
1. Turn the telephone upside down so that you can see the
bottom of the telephone. See Figure 2.
Desktop
stand
Figure 2. The Bottom of the 6200 Series Telephones
2. Remove the desk stand by sliding it to the left until it is
free of the telephone base. See Figure 3.
Desktop
stand
Figure 3. Sliding the Base from the Bottom of the Set
3. Plug one end of the line cord into the line jack on the
bottom of the telephone.
4. Align the other end of the line cord so that it is threaded
through the slot at the top of the stand. See Figure 4.
5. Reattach the stand to the telephone by sliding the stand
into the appropriate tabs and to the right.
Line cord
Desktop
stand
Figure 4. Attaching the Line Cord and Threading It
Through the Slot at the Top of the Desktop Stand
Line jack
4 holes for
wall mounting
Slide stand
to left and lift
Line jack
LINE
6. After you have attached the stand to the telephone, use
the screw provided to tighten the stand onto the back of
the telephone set.
Figure 5. Tightening the Stand to Back of the
Telephone
7. Turn the telephone right-side up and place it on your
desk or table.
8. Plug one end of the coiled handset cord into the handset
jack on the side of the telephone.
9. Plug the other end of the handset cord into the handset.
10. Hang up the handset.
11. Plug the free end of the line cord into a modular wall
jack.
12. Lift the handset and listen for dial tone.
13. Set the Ringer volume control (labeled
the setting you want.
WALL INSTALLATION
Use the following directions to mount the telephone on a
standard wallphone jack with mounting studs.
NOTE:
For wall installation, use an 8-inch cord
(PEC: 2725-02A; Comcode: 103789293) rather than
the 14-foot cord that is packaged with the telephone.
1. You must reverse the handset tab (which holds the
handset when you hang up). See Figure 5.
• Hold down the switchhook and slide the handset tab
up and out of its slot.
• Turn the tab so that the curved end is facing up.
• Insert the tab back into its slot.
a. Handset
retainer
in place
c. Reposition
handset
(up
retainer
down
position)
(down
position)
Figure 6. Reversing the Handset Hook
2. Turn the telephone upside down so that you can see the
bottom of the telephone.
3. Remove the mounting base by sliding the base to the
left until it is free of the telephone. See Figure 3.
4. Turn the base so the larger end is down.
5. Plug one end of the 8-inch line cord into the line jack on
the bottom of the telephone.
2
)
b. Press to release
and then remove
handset retainer
d. Replace handset
retainer
to