Makita 12V 8413D Buku Petunjuk - Halaman 8
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 12V 8413D. Makita 12V 8413D 19 halaman. 12v / 14.4 v / 18 v cordless percussion-driver drill equipped with electric brake
Halaman Cetak
FUNCTIONAL DESCRIPTION
Installing or removing battery cartridge
*Always switch off the tool before inser-
tion or removal of the battery cartridge.
*To remove the battery cartridge, with-
draw
it
from the tool while pressing the
buttons
on
both sides of the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Always insert it all the way until it
locks in place with a little click. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
Battery cartridge
1
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
easily, it is not being inserted correctly.
Charging
Your new battery cartridge is not charged.
You will need to charge it before use. Use
the high capacity battery charger Model
DC1411 (for 841 3D and 8433D)
/
DC1801
(for 8443D) to charge the battery car-
tridge.
Plug the high capacity battery charger into
the proper A.C. voltage source. The
charging light will flash in green color.
*Insert the battery cartridge so that the
DIUS and minus terminals on the batterv
Battery cartridge
Charging light
-
cartridge are on the same sides as their respective markings on the high capacity battery
charger. Insert the cartridge fully into the port so that it rests on the charger port floor.
When the battery cartridge is inserted, the charging light color will change from green to
red and charging will begin. The charging light will remain lit steadily during charging.
When the charging light color changes from red to green, the charging cycle is complete
and the charger will switch into its "trickle charge (maintenance charge)" mode. The
charging time is approximately one hour.
*After charging, unplug the charger from the power source.
CAU TI0
N
:
*The high capacity battery charger Model DC1411
/
DC1801 is for charging Makita battery
cartridge. Never use it for other purposes or for other manufacturer's batteries.
When you charge
a
new battery cartridge or a battery cartridge which has not been used
for a long period of time, it may not accept a full charge. This is a normal condition and
does not indicate a problem. You can recharge the battery cartridge fully after discharging
it completely and recharging a couple of times.
8