Makita 197413-5 Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 197413-5. Makita 197413-5 12 halaman. Cordless cutter
Juga untuk Makita 197413-5: Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman)

Halaman Cetak

► 1 . Shaft lock 2. Hex wrench 3. Tighten 4. Loosen

► 1 . Hex bolt 2. Outer flange 3. Diamond wheel

4. Inner flange 5. Arrow

To remove the diamond wheel, press the shaft lock fully

so that the diamond wheel cannot revolve and use the

hex wrench to loosen the hex bolt counterclockwise.

Then remove the hex bolt, outer flange and diamond

wheel.

To install the diamond wheel, follow the removal pro-

cedure in reverse. Make sure the diamond wheel is

installed so that the arrow on the wheel points in the

same direction as the arrow on the diamond wheel

case.

BE SURE TO TIGHTEN THE HEX BOLT SECURELY.

► 1 . Hex bolt 2. Outer flange 3. Diamond wheel

4. Inner flange 5. Protrusion (bigger side)

NOTE: If an inner flange is removed by chance,

install the inner flange so that its protrusion (bigger

side) faces inside as shown in the figure.

Hex wrench storage

► 1 . Hex wrench

When not in use, store the hex wrench as shown in the

figure to keep it from being lost.

Installing water supply

Loosen the screw A.

Slide the tank holder all the way over the motor housing so

that the notch of the band (part of the tank holder) is posi-

tioned just below the screw head of the tool as illustrated.

Then tighten the screw A.

► 1 . Screw A 2. Tank holder 3. Motor housing 4. Notch

of the band (part of the tank holder) 5. Screw head

of the tool

Attach the tank on the tank holder so that the tank

holder fits between the step and dots. Connect the cap

on the tube end to the mouth of the tank. Turn the tank

clockwise. Then tighten the screw B.

► 1 . Tank 2. Tube 3. Screw B

8 ENGLISH