Makita 6010D Buku Petunjuk - Halaman 7
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6010D. Makita 6010D 14 halaman. 10 mm (3/8")
Juga untuk Makita 6010D: Buku Petunjuk (17 halaman)
Halaman Cetak
Bit installation & removal
CAUTION :
Always set the Forward-Reverse switch lever to NEUTRAL when installing, removing or
adjusting bits or accessories.
Chuck
When installing
a
drill bit, notice that
there are three holes in the chuck
a t
which you must use the key for tighten-
ing. Insert the chuck key in any of the 3
holes and turn to the left (counterclock-
wise) to release jaws of chuck. Insert the
bit and tighten with chuck key to the
right. Tighten evenly
a t
a l l
three holes in
sequence.
1
Clip-on
chuck
key
Overload protector
The overload protector automatically
cuts in t o break the circuit and the
button pops out, whenever heavy work i s
prolonged. Wait 20-30 seconds before
pressing the restart button (on housing
in back) to resume operation. Your finger
should not be on the trigger when you
press the restart button, however.
/
Overload protector
I"