Makita 601DST Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 601DST. Makita 601DST 15 halaman. 10 mm (3/8") battery-powered driver dril

ADDITIONAL SAFETY RULES FOR CHARGER

1. The Makita charger Model DC122 is specifically designed t o charge only

the Makita battery 121 or

122. Do

not attempt t o charge any other battery

with this charger.

2. Handle the charger carefully. Do not drop or strike

it.

Never carry the charger by cord or yank it t o disconnect from receptacle.

4. Keep cord from heat, oil, chemicals, and sharp edges.

5. Use only a power source of the same voltage as indicated on the nameplate

Do not attempt t o use a step-up transformer, an engine generator or DC

7. Charge the battery at a room temperature of 10°C (5OOF)

4OoC (104OF).

Do not charge in place exposed t o direct sunlight.

Do not allow the charger t o get wet.

I O .

Do not charge inside a box or container of any kind.

11.

Do not charge near volatile, flammable material such as gasoline, paint, gas,

12.

Do not charge on top of paper, carpet, vinyl sheeting, cloth materials, etc.

13.

Do not allow anything t o cover or clog the charger vents. Do not attempt

14. Do not charge in dusty place.

15. Stop charging immediately

you notice anything abnormal. Ship or take the

charger and the battery t o your nearest Makita Service Center or Distributor

for checking them.

of the charger when charging.

power receptacle.

adhesive, etc.

t o insert anything into the vents.

16.

Do not attempt t o disassemble or make modifications t o the charger.

17. Do not put any metal objects or foreign matter into the inlet of the charger.

Short-circuit will occur, causing a burn injury and charger breakdown.