Makita 6073D Buku Petunjuk - Halaman 9
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6073D. Makita 6073D 16 halaman. Equipped with electric brake 10 mm (3/8”) with fast charger
Halaman CetakAdjusting fastening torque
The fastening torque can be adjusted in six
stages by turning the adjusting ring so that
the pointer
on
the adjusting ring points
to
a number o n the tool body. The fastening
torque
is
minimum when t h e pointer
points to the number
1
and maximum
when it points to the
-8-
marking. The
clutch will slip at varying torque levels
when the pointer is set at the numbers
1 to
5. The clutch is designed not to slip at the
.\-
marking.
. .
Before actual operation, drive a trial screw into your material or
a
piece of duplicate
material t o determine which torque level is required for a particular application.
NOTE :
The adjusting ring cannot be locked with the pointer positioned half-way between the
numbers.
Screwdriving operation
Place the point
of
the driver bit in the
screw head and apply pressure t o the tool.
Start the tool slowly and then increase the
speed gradually. Release the trigger
as soon
as the clutch cuts
in.
9