Makita 6093DW Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6093DW. Makita 6093DW 16 halaman. Equipped with electric brake 10 mm (3/8") with fast charger
Juga untuk Makita 6093DW: Buku Petunjuk (17 halaman)

Makita 6093DW Buku Petunjuk
IMPORTANT
SAFETY INSTRUCTIONS
1 SAVE THESE INSTRUCTIONS - This manual
contains
important
safety
and operating
instructions
for battery
charger,
2. Before using battery
charger, read all instructions
and cautionary
markings
on (11 battery
charger,
(21 battery,
and (31 product
using battery.
3. CAUTION
-- To reduce
risk of injury, charge
only MAKITA
Battery
7000,
9000
or 9100.
Other types of batteries
may burst causing
personal
injury
and damage.
4. Do not expose
charger
to rain or snow.
5. Use of an attachment
not recommended
or sold by the battery
charger
manufacturer
may result in a risk of fire, electric shock, or injury to persons.
6. To reduce risk of damage
to electric plug and cord, pull by plug rather than
cord when
disconnecting
charger.
7. Make sure cord is located
so that it will not be stepped
on, tripped
over,
or otherwise
subjected
to damage
or stress.
8. An extension
cord should not be used unless absolutely
necessary.
Use of
improper
extension
cord could result in a risk of fire and electric
shock. If
extension
cord must be used, make sure:
a. That pins on plug of extension
cord are the same number, size, and shape
as those of plug on charger;
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified
in the table below.
TABLE 1
RECOMMENDED
MINIMUM
AWG SIZE FOR
EXTENSION
CORDS
FOR BATTERY CHARGERS
Length of Cord (Feet)
25
50
100
150
AWG Size of Cord
18
18
18
16
9. Do not operate
charger
with damaged
cord or plug -- replace
them
im-
mediately.
10. Do not operate
charger
if it has received
a sharp blow, been dropped,
or
otherwise
damaged
in any way; take it to a qualified
serviceman.
11. Do not disassemble
charger
or battery
cartridge;
take
it to a qualified
serviceman
when service
or repair is required.
Incorrect
reassembly
may
result in a risk of electric
shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance
or cleaning. Turning off controls will not reduce this risk.