Makita 6223DE Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6223DE. Makita 6223DE 16 halaman. Equipped with electric brake

Installing or removing battery cartridge

*Always switch off the tool before insertion or removal of the battery cartridge

*To remove the battery cartridge, withdraw

it from the tool while pressing the buttons

on both sides of the cartridge.

*To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip it into place.

Always insert it all the way until it locks in

place with a little click. If not, it may acci-

dentally fall out of the tool, causing injury

to you or someone around you.

*Do not use force when inserting the battery cartridge.

If the cartridge does not slide in easily, it is not being inserted correctly.

Charging

Plug the fast charger into your power

source. Insert the battery cartridge so that

the plus and minus terminals on the battery

cartridge are on the same sides as their

respective markings on the fast charger.

Insert the cartridge fully into the port so

that it resets on the charger port floor.

The charging light will come on and charg-

ing will begin. If the charging light goes out

soon, remove the battery cartridge from the

charger and let it cool off for more than one

minute, Then re-insert it and try to charge it once more. If the charging light goes out with-

in one minute even after repeating this procedure a couple of times, the battery cartridge

is dead. Replace it with a new one.

When the charging light goes out after about one hour, you may remove the fully charged

battery cartridge.

After charging, unplug the charger from the power source.

CAUTION:

*Your new battery cartridge is not charged. You will need to charge it before use.

*If you try to charge a cartridge from a just-operated tool, sometimes the charging light will

not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it and try

to charge it once more.

*When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period, it may not accept a full charge. This is a normal condition and does not

indicate a problem. You can recharge the battery cartridge fully after discharging

almost

completely a couple of times.

*If you wish to charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.