A&E Systems Electrolux AW300 Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Aksesori A&E Systems Electrolux AW300. A&E Systems Electrolux AW300 8 halaman. Direct mounting case awning for mini-motorhomes, pick-up campers, vans, van conversions & pop-up tent trailers

Halaman Cetak

into place to lock awning in full extension. Listen for "Click"

of Rafter Lock Buttons and continue to pull on Pull-Strap to

make sure that Rafter Locks are fully set before releas-

ing Pull-Strap.

Tighten Lock Knobs. Fig. 5C.

PARTIAL EXTENSION

For partially extended awning operation, roll fabric out to

desired extention and while firmly grasping Pull-Strap

tighten Rafter Lock Knobs. Fig. 5D.

NOTE: Make sure that Rafter Lock Knobs are tightened

before releasing Pull-Strap.

FOR PATIO POSITION:

Place

a vertical position and adjust

Arm Assembly in

height. Fig. 6.

Drive in the supplied Spikes through awning Foot to

secure arm to ground. Fig. 7. Repeat for other side.

The Electrolux

AW Awning is now ready for you to enjoy.

RAIN RELEASE SETTING

8. Rain

Setting: To avoid damage to the awning

Release

due to rain water collecting on the canopy, simply lower

one of the arms enough to let the water drain from that

side. Fig. 8.

TO CLOSE

TO CLOSE ON STRAIGHT SIDEDVEHICLE

1. IF AWNING IS SET IN PATIO POSITION:

Remove

Spikes from awning Foot.

B. Attach Foot to Bottom Mounting Bracket on side of

vehicle to set awning into Pivot Position. Fig. 1.

Repeat for other side. Then proceed to Step 2.

2. IF AWNING IS SET IN PIVOT POSITION:

Lower each Arm Assembly to closing position indicated

by arrow on Inner Arm and tighten Lock Knob. Fig. 2.

3. Firmly grasp Pull-Strap and loosen Lock Knobs. Fig. 3A.

While tightly holding Pull-Strap pull on Strap to relieve

pressure from Rafter Lock Buttons and push Rafter

Lock Buttons in to unlock rafters and allow awning to

roll up. Fig. 3B.

Make sure Pull-Strap is centered in awning Case.

4. Loosen Lock Knob on each Arm Assembly. Fig. 4.A.

Remove awning Feet from Bottom Mounting Brackets.

Figs. 4B. and 4C.

4B.

AWNING CASE -

PIN -OUTER