Alien Flier EZ-Up Panduan Pemasangan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemasangan untuk Olahraga & Luar Ruangan Alien Flier EZ-Up. Alien Flier EZ-Up 3 halaman. Zip line

Halaman Cetak

Step 9.

Using the 3 cable clamps and a 7/16"

wrench, loop the cable and create the

eye. Make sure the eye is 2 ½ -3 inches

long. Install the cable clamps as in the

photo - all facing the same direc on.

Make sure they are snug but not ght as

you may have to adjust the posi on of

the eye. Once the eye posi on is

ﬁnalized, ghten the clamps.

Step 13.

A ach the hook on the black ratchet to

the cable eye.

EZ-Up Zip Line Installa on Guide

Tools Needed: 7/16" wrench

Mount your zip line to healthy, live trees that are at least 12" in diameter and ﬁrmly rooted in the ground!

Step 10.

Slide the webbing and mesh assembly

up the tree to create a grade NO

G R EAT E R

t h a n

3 - 4 %

. Yo u

M U ST

compensate for the slope of the land if

you are not installing over level ground.

Use an Inclinometer App or a qualiﬁed

contractor to insure the angle of your

line is within these limits. You can use a

string or zip e to hold the assembly

ghtly around the trees for posi oning.

Step 14.

Tighten the black ratchet to the desired

cable tension to eliminate sag in the line.

Step 11.

A ach the small hook on to the cable

eye that you created.

Finishing Up

Adjustment between the red and black ratchet and

webbing may be necessary. When the black webbing is

at the desired tension, loosen the red safety line, pull the

webbing taut, and re- ghten the red safety link.

Be sure that the ratchet barrels do not become too full.

Coil any excess cable or red safety link and secure with a

zip e.

Make sure both ratchets are in the closed/locked

posi on.

WARNING

INSTALLATION

USE

of Alien

Flier products is

prohibited

until

you have

read

and

understood

the

Installation Manual, Warnings,

Assumption of Risk Statement &

Liability Waiver.

Step 12.

Thread the red safety link webbing

through the slot in the base of the hook.

Then thread it through the ratchet

slot/barrel and pull it

ratche ng un l the black ratchet and

hook can be a ached to the cable eye.

INSPECT ENTIRE SYSTEM FOR WEAR,

DAMAGE & SERVICEABILITY BEFORE

EACH USE.

CHECK YOUR WORKMANSHIP & ALL

CONNECTIONS PRIOR TO EVERY RIDE!

ght. Begin