AC Fire Pump Series 1580 Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pompa Air AC Fire Pump Series 1580. AC Fire Pump Series 1580 8 halaman. In-line mounted centrifugal fire pumps

Halaman Cetak
SAFETY
INSTRUCTIONS
This safety alert symbol will be used in this manual and on
the unit safety instruction decals to draw attention to safety
related instructions. When used, the safety alert symbol
means ATTENTION! BECOME ALERT! YOUR SAFETY IS
INVOLVED! FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN A SAFETY HAZARD.
Your Series 1580 Inline Mounted Centrifugal Fire Pump
should have the following safety instructions decals approxi-
mately as shown. If the decals are missing or are illegible
contact your local A C Fire Pump Systems representative for
a replacement.

ADDITIONAL SAFETY REQUIREMENTS:

ELECTRICAL SAFETY:

WARNING: Electrical Shock Hazard
Electronical connections to be made by a qualified
electrician in accordance with all applicable codes,
ordinances, and good practices. Failure to follow these
instructions could result in serious personal injury or death,
and property damage.
WARNING: Electrical Overload Hazard
Three phase motors must have properly sized heaters
to provide overload and under voltage protection. Single
phase motors have built-in overload protectors. Failure to
follow these instructions could result in serious personal
injury or death, and property damage.

THERMAL SAFETY:

WARNING: Extreme Temperature Hazard
If pump, motor, or piping are operating at extremely
high or low temperature, guarding or insulation is required.
Failure to follow these instructions could result in serious
personal injury or death, and property damage.
2
WARNING
EYEBOLTS OR LIFTING
LUGS IF PROVIDED ARE
FOR LIFTING ONLY THE
COMPONENTS TO WHICH
THEY ARE ATTACHED.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY
OR DEATH.
P70643
CAUTION
DO NOT RUN PUMP DRY,
SEAL DAMAGE MAY OCCUR.
INSPECT PUMP SEAL
REGULARLY FOR LEAKS,
REPLACE AS REQUIRED.
FOR LUBRICATION
REQUIREMENTS, CONSULT
SERVICE INSTRUCTIONS.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY OR
PROPERTY DAMAGE.
P70644

MECHANICAL SAFETY:

WARNING: Unexpected Startup Hazard
Disconnect and lockout power before servicing.
Failure to follow these instructions could result in serious
personal injury or death, and property damage.
WARNING: Excessive System Pressure Hazard
The maximum working pressure of the pump is listed
on the nameplate, do not exceed this pressure. Failure to
follow these instructions could result in serious personal
injury or death, and property damage.
WARNING: Excessive Pressure Hazard
Volumetric Expansion
The heating of water and other fluids causes volumetric
expansion. The associated forces may cause failure of
system components and release of high temperature
fluids. This will be prevented by installing properly sized
and located compression tanks and pressure relief valves.
Failure to follow these instructions could result in serious
personal injury or death, and property damage.
Fig. 1
WARNING
ROTATING COMPONENTS
DISCONNECT AND LOCKOUT
POWER BEFORE SERVICING.
DO NOT OPERATE WITHOUT
ALL GUARDS IN PLACE.
CONSULT INSTALLATION
AND SERVICE INSTRUCTION
SHEET BEFORE OPERATING
OR SERVICING.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY
OR DEATH.
P70642