Align Trex SE Setup Manual - Halaman 12

Jelajahi secara online atau unduh pdf Setup Manual untuk Mainan Align Trex SE. Align Trex SE 14 halaman. Helicopter

Align Trex Se Setup Guide

**NOTES**

Flight Mode Switch

Switch at 0 = pitch settings of -3, 0, +10 and throttle curve of 0, 60, 100.

Swithc at 1 = pitch settings of -10, 0, +10 and throttle curve of 100, 80, 100.

Throttle Hold Switch

Switch at 0 = Normal operation

Switch at 1 = No motor operation

Aileron D/R Switch

Switch at 0 = Gyro Head Hold Mode ON ( should remain in this mode)

Switch at 1 = Gyro Head Hold Mode OFF

Elevator D/R Switch

Factory default on both 0 and 1

Dual rate settings should be at factory default unless you made changes outside these instructions. Its

always better to double check.

Radio settings, rates, degrees and any measurements shown in this guide are from my working SE. Do not

assume that by using the same values you will get the same results. Please verify all your settings and

general operation of you heli.

http://www.digimemphoto.com/pdf/ (12 of 13)1/25/2006 7:09:05 PM

If you get the mesh at the high side to where there is no gap, then your low side mesh

should be correct. If its not then your gear is seriously out of round and probably not suitable

to use. A gap as in the last image will result in a stripped gear.