Align-Pilates A2 Manual Petunjuk Perakitan - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Peralatan Kebugaran Align-Pilates A2. Align-Pilates A2 16 halaman. Full cadillac

Halaman Cetak

6. Inserting the poles

Ensure the grub screws are loose on all four corners to allow the poles to slot into the receptacles,

(Fig.8). Once you have done this you can insert the two head end uprights, one at a time, into

the receptacles. (Note: The head end uprights have three holes drilled through half way up). Slide

the black quick adjust carriages over the top of each pole and tighten in position, see Fig.9. Be

sure that these uprights are installed at the same end of the frame that has the 4 holes for the

headrest.

Fig. 9

Fig. 8

Insert the other pair of poles in the opposite end with the drilled holes at the top. Once they are

all connected, slide over the roll down bar frame at the foot end as per Fig.10.

Fig. 10

7. Attaching the trapeze carriage

Insert the black corner caps in each upright. (Note: there is only

one way they will all slot in correctly, so take your time and align

the holes correctly). Next, insert the x2 short end pieces.

Slide the trapeze carriage over each of the horizontal cross bars

and insert one end at a time into the corner pieces. Align all the

holes ready for the bolts and then use the bolts with the contoured

Fig. 11

washers and rounded caps, screw each bolt upward through the

horizontal frame pieces.

At each corner use the bolts with eyelets to attach the uprights to

each black corner piece, Fig.11. Use the x4 black knobs to

position the sliding trapeze frame and the roll down bar frame in

place. These simply screw in as per Fig.12.

Fig. 12