AEG 7000 Series Panduan Pengguna - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven AEG 7000 Series. AEG 7000 Series 32 halaman.
Juga untuk AEG 7000 Series: Panduan Pengguna (32 halaman), Panduan Pengguna (44 halaman), Panduan Pengguna (49 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna (36 halaman)
11.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
er does not op‐
The On/Off button was not pushed. Push the On/Off button.
erate.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Dryness Level option was set to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possible
After a cycle starts it is not possi‐
to change the
ble to change the programme or
programme or
option.
option.
It is not possible
The option you tried to select is not
to select an op‐
available for the selected pro‐
tion. An acoustic
gramme.
signal is emit‐
ted.
There is no
Defective drum lamp.
drum light
Possible cause
3)
iron dry .
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Touch the Start/Pause button.
Push the On/Off button.
Select a suitable programme.
2)
Clean the filter.
Change Dryness Level option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Contact the service centre to re‐
place the drum lamp.
ENGLISH
23
1)
4)
2)