Garmin Camper 890 Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk GPS Garmin Camper 890. Garmin Camper 890 32 halaman.
Halaman Cetak
Getting Started
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
• Update the maps and software on your device
Maps and Software Using a Wi
• Mount the device in your vehicle and connect it to power
(Mounting and Powering the Device in Your Vehicle,
page
1).
• Adjust the volume
(Adjusting Sound and Notification Volume,
page
19) and display brightness
Brightness, page
3).
• Set up a vehicle profile for your camper
Profile, page
3).
• Navigate to your destination
Device Overview
Microphone for hands-free calling and voice command
Volume control
Power key
Micro USB power and data port
Map and data memory card slot
Magnetic mount interface with 14-pin connector
Speaker
Mounting and Powering the Device in Your
Vehicle
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause interference with some
Getting Started
WARNING
(Updating
‑ Fi Network, page
20).
(Adjusting the Screen
(Adding a Vehicle
(Starting a Route, page
WARNING
internal medical devices and electronic devices, including
pacemakers, insulin pumps, or hard drives in laptop computers.
Keep the device away from medical devices and electronic
devices.
Before you use your device on battery power, you should charge
it.
1
Open the lever
and flip the lever back toward the windshield.
The lever must be oriented toward the top of the windshield.
5).
2
Plug the vehicle power cable into the port
3
If necessary, loosen the thumbscrew on the suction cup arm
and the nut on the ball mount
better viewing and operation.
4
Tighten the thumbscrew on the suction cup arm and the nut
on the ball mount.
5
Place the device onto the magnetic mount.
6
Plug the other end of the vehicle power cable into a power
outlet in your vehicle.
, press the suction cup to the windshield,
, and adjust the mount for
on the mount.
1