Garmin Zumo 550 - Motorcycle GPS Receiver Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk GPS Garmin Zumo 550 - Motorcycle GPS Receiver. Garmin Zumo 550 - Motorcycle GPS Receiver 30 halaman. Declaration of conformity
Juga untuk Garmin Zumo 550 - Motorcycle GPS Receiver: Panduan Referensi Cepat (2 halaman), Lembar Instalasi (2 halaman), Panduan Referensi Cepat (2 halaman), Informasi Produk (4 halaman), Pernyataan Kesesuaian (1 halaman), Panduan Petunjuk Instalasi (46 halaman)

Garmin Zumo 550 - Motorcycle GPS Receiver Panduan Pemilik
G
S
ETTING
TARTED

Step 1: Connecting Power to the Mount

Select a suitable location to mount the zūmo on your motorcycle based on available
power sources and safe power cable routing.
Power connector
Step 2: Mounting the zūmo
This section illustrates two possible installation solutions: A) install the U-bolt on the
handlebar and B) install the handlebar base to the clutch/brake clamp bracket. Custom
mounts may require additional hardware (xref to Ram Web site?).
A) To install the U-bolt and handlebar
base:
1. Place the U-bolt around the handlebar,
and thread the ends through the
handlebar base.
2. Tighten the nuts to secure the base.
2
Bare wires with inline fuse for
power connection
Handlebar
base
Handlebar
zūmo 500/550 Owner's Manual
B) To install the handlebar base to the clutch/brake clamp bracket:
NOTE: Both 1/4" standard and M6 bolts are included. Match the size of the factory
bolts on your clutch/brake clamp braket.
1. Remove the two factory bolts
on your clutch/brake clamp
bracket.
2. Thread the new bolts through
the handlebar base, spacers,
and clamp bracket.
3. Tighten the bolts to secure the
base.
To attach the base plate to the
zūmo cradle mount:
1 Thread the M4 x 40mm flathead
U-bolt
bolts and nuts to attach the base
plate to the zūmo cradle mount.
2. Tighten the nuts to secure the
base plate.
zūmo 500/550 Owner's Manual
G
S
ETTING
TARTED
Handlebar
Clutch/brake
base
clamp bracket
Spacers
zūmo cradle
mount
Base plate
3