Aliyiqi HF-500 Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Uji Aliyiqi HF-500. Aliyiqi HF-500 15 halaman. Hf digital display push-pull force gauge

Halaman Cetak

1. \"Boot \" key

When this button is pressed, the power is turned on and the model number is displayed. After booting, before

you press \"Clear \" to clear, the zero drift value of the analog signal may be displayed on the screen, just press

\"Clear \" to clear.

2. \"Shutdown \" key

In the power-on state, when you press this button, the power is turned off, but the stored data will not disappear.

When the power is turned on (that is, when the model is displayed and the measurement interface 0.00 is not

displayed), pressing the shutdown key at this time is unresponsive.

3. \"Save \" key

In the peak measurement interface state, press this key to save the test data displayed on the screen; in the

function setting interface state, press this key to save the set parameters. When the test data is stored in the

machine, \"MEM \" is displayed. This machine can store 447 data.

4. \"Settings \" key

For detailed settings, please refer to the description of various setting methods in \"Function Introduction \".

5. \"Unit \" key

Press this key to switch between measurement units, and three units of N (Newton), kg (Kilogram), and lb

(Pound) can be displayed cyclically. In the test data display state, the unit conversion of the same value can also

be completed. In the specifications above HF10K, it is composed of the letters \"K \" \"KN (kilo-newton) \", \"Kkg

(ton) \", \"Klb (kilo-pound) \".

6. \"Peak \" key

Each time you press this key, there will be a switch between \"PEAK \" display, \"AUTO PEAK \" display or

\"PEAK \" disappearing-that is, peak hold, peak hold automatic release, and real-time load value switching.

7. \"Rotate \" key

This key is only valid in the test interface. When you press this key, the measured value displayed on the screen

will rotate 180 degrees.

8. \"View \" key

When you press this key, the stored test data will be recalled and displayed on the screen. At this time, the

word\"\" MEM \"flashes-the number of saves is displayed first, and the saved data is automatically displayed

after 2 seconds. Press \"Zero \" to return to the measurement interface.

9. \"Zero \" key

When this key is pressed, the test value on the screen will be reset to zero. Note: When the instrument is

cleared, the instrument can only be cleared in the real-time measurement mode under peak and automatic peak.

※ Choose a lighter fixture or remove the added load and clear it again.

※ In the \"View \" interface, press and hold this button for 4 seconds, all the stored test data can be cleared

(may not be cleared in some states, then restart the machine after shutdown and then execute this function to

clear all saved data) .