Garmin GPSMAP 800 Series Adendum Panduan Pilot - Halaman 12

Jelajahi secara online atau unduh pdf Adendum Panduan Pilot untuk Sistem Navigasi Mobil Garmin GPSMAP 800 Series. Garmin GPSMAP 800 Series 22 halaman. Flat-mount kit
Juga untuk Garmin GPSMAP 800 Series: Panduan Memulai Cepat (17 halaman), Panduan Pemilik (40 halaman), Panduan Memulai Cepat (4 halaman), Panduan Pemilik (46 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Operator (32 halaman), Panduan Petunjuk Instalasi (34 halaman), Panduan Petunjuk Instalasi (6 halaman)

GTS 8XX Interface

1.7

SWITCHING BeTWeeN STANDBy AND OPeRATING MODeS

The unit must be in operating mode for traffic to be displayed. The ability to switch

out of standby into operating mode on the ground is especially useful for scanning

the airspace around the airport before takeoff. Operating Mode is confirmed by the

display of 'OPER' in the upper right-hand corner of the Traffic Page (Figure 4).

Switching to Operating Mode from Standby Mode:

Press the small right knob to activate the cursor and highlight 'STBY'.

Turn the small right knob to select 'OPER?'.

Press the ENT Key to confirm and place the GTS 8XX in operating mode,

the GTS 8XX switches out of standby into the 6-nm display range.

NOTE: The GTS 8XX will automatically switch out of standby 8 to 10 seconds

after takeoff, which is determined by ground speed or by a transition of the

aircraft squat switch (if connected).

Switching to Standby Mode from the Traffic Page:

Press the small right knob to activate the cursor and highlight 'OPER'.

Turn the small right knob to select 'STBY?'.

Press the ENT Key to confirm and place the GTS 8XX in standby mode.

NOTE: The GTS 8XX goes into standby mode 24 seconds after landing, which

is determined by ground speed or by a transition of the aircraft squat switch

(if connected). This delay allows the GTS 8XX to remain out of standby during

a touch-and-go maneuver.

400/500 Pilot's Guide Addendum for GTS 8XX Interface

190-00140-78 Rev. A