Brother 885-X03 Panduan Pengoperasian - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Mesin Jahit Brother 885-X03. Brother 885-X03 48 halaman.
Juga untuk Brother 885-X03: Panduan Pengoperasian (48 halaman), Panduan Pengoperasian (48 halaman)

Halaman Cetak
Brother 885-X03 Panduan Pengoperasian
KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Replace the bobbin cover. Put the
6
projection into the race retainer groove
and push closed.
1
2
1 Groove
2 Projection
• Make sure that the end of the thread comes
out from the cover toward the rear of the
machine (as shown in the illustration).
• Draw up the lower thread before starting
sewing. Refer to "Drawing up the lower
thread" on page 19 after threading the upper
thread.
Lower threading (for
models equipped with a
quick-set bobbin)
Install the bobbin wound with thread.
This feature is only available on certain models.
Follow steps
to
1
1
threading" on page 14.
While lightly holding down the bobbin
2
with your right hand as shown, guide the
thread through the slit (1 and 2). Then,
pull the thread toward you to cut it with
the cutter (3).
• At this time, check that the bobbin easily
rotates counterclockwise.
2
1
2
3
1 Slit
2 Cutter (Cut the thread with the cutter.)
15
from "Lower
4
1
Note
● If the thread is not correctly inserted through
the tension-adjusting spring of the bobbin
case, it may cause incorrect thread tension.
1
1 Tension-adjusting spring
Replace the bobbin cover. Put the
3
projection into the race retainer groove
and push closed.
1
2
1 Groove
2 Projection
• Start sewing after threading the lower and
upper thread. When sewing gathers or darts,
you can draw up the lower thread by hand so
that some thread will be left over. Refer to the
steps in "Drawing up the lower thread"
(page 19).