AlkaWay Ultrastream Undersink Kit Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Penyaringan Air AlkaWay Ultrastream Undersink Kit. AlkaWay Ultrastream Undersink Kit 12 halaman.

Halaman Cetak

1. Cold Water Connection

1. Turn off the cold-water supply by

the shut-off valve below the sink or

at the house water mains.

2. After shutting off the water, open

the kitchen faucet to drain out

the remaining water in the line.

Optional, turn on a garden tap to

drain the water line.

3. Place a container under the shut

off valve to capture any water left

in the system.

4. Disconnect the cold-water line by

unscrewing the braided tube nut

(see images a and b).

5. Install the cold-water connector

(the Angle Stop Valve). Ensure it's

in the OFF position, as shown in

images c and d).

6. Reconnect the cold-water line (the

braided tube) by screwing on to the

installed cold-water connector.

2. Vented Faucet Hole

1. Cut out the drilling template image.

2. Before drilling place tape on the surface where the hole will be drilled.

3. Choose a location on the sink or benchtop where the UltraStream vented faucet

spout may flow into the sink both when it is on and when it is off.

4. Centre mark the hole.

5. Drill the hole (NOTE: Always use an expert when drilling into stone or marble

benchtops).

6. Remove sharp edges and deburr the hole. This is to protect your hands and the

tubes when feeding the tubes through the hole.

For videos, help and support go to www.alkaway.com.au/support