Garmin echomap 40 series Panduan Pilot - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pilot untuk Sistem GPS Kelautan Garmin echomap 40 series. Garmin echomap 40 series 22 halaman. Vhf comm
Juga untuk Garmin echomap 40 series: Panduan Petunjuk Instalasi (15 halaman), Panduan Pemilik (32 halaman), Pernyataan Kesesuaian (1 halaman), Panduan Pemilik (30 halaman), Panduan Pemilik (50 halaman)

Getting Started

Annunciators and Controls

TX - Transmit\

s - Standby Frequency

m - Monitor Mode

I - Intercom

Annunciators

Volume, Power, and Squelch Control

Large (outer)

and

Small (inner)

knobs

Flip/Flop Button

Annunciators

Several annunciators are used to help indicate the operating modes of your SL40. The

TX (Transmit) annunciator is lighted whenever you are transmitting. If the avionics bus

drops below 9 VDC, the SL40 will not transmit. An LED will be lighted above the MON

and RCL buttons when these functions are selected. An "s" will appear to the left of the

Standby frequency. An "m" will appear to the left of the Standby frequency when you are

using the Monitor function. An "I" indicates the Intercom function is being used.

The knob on the left side of the SL40 controls power on/off, volume, and squelch test.

Rotate the knob clockwise (CW) past the detent to turn the power on. Continuing to ro-

tate the knob to the right increases speaker and headphone ampliﬁer volume level. Rotate

the knob to the left to reduce the volume level. Pull the knob out to disable automatic

squelch. The SL40 may be installed to have the on/off switch disabled and to have power

controlled from the avionics panel.

The dual concentric knobs on the right side of the SL40 are used to select frequencies or to

view the features available within a function. Details are provided in the appropriate section.

Five backlighted buttons allow you to access the functions in your SL40.

Press the Flip/Flop button to switch between the active (left-most) and standby (right-

most) frequency. Switching between frequencies is disabled while you are transmitting.