Garmin GHP 10 Catatan Konfigurasi - Halaman 2

Jelajahi secara online atau unduh pdf Catatan Konfigurasi untuk Sistem GPS Kelautan Garmin GHP 10. Garmin GHP 10 14 halaman. Autopilot system, addendum
Juga untuk Garmin GHP 10: Panduan Petunjuk Instalasi (48 halaman), Panduan Petunjuk Instalasi (26 halaman), Panduan Pemilik (28 halaman), Pernyataan Kesesuaian (1 halaman), Referensi (1 halaman)

Evaluating the Results of the Autopilot Configuration

When the Dockside and Sea Trial Wizards are complete, test the autopilot to be sure it is configured correctly. Test the autopilot first at slow

speeds (below planing), and then test the autopilot at planing speeds.

To test the autopilot configuration:

1. Drive the boat in one direction with the autopilot engaged (heading hold). The boat should not oscillate significantly; however, a small

amount of oscillation is normal.

2. Turn the boat in one direction using the autopilot. When you release the turn button, the boat should overshoot the turn and quickly correct

the heading to the point at which you released the button. You will notice that the faster you are going, the greater the boat will overshoot the

turn.

3. If the autopilot is configured properly at slow speeds, repeat these tests at planing speed, and vice versa.

To adjust the autopilot configuration if necessary:

1. If you feel that the heading hold oscillates significantly or that the autopilot does not quickly correct the heading when turning, you can make

slight adjustments to the rudder gain.

NOTE: When you manually adjust the rudder gain (or counter gain), make small adjustments, and adjust only one value at a time. Test the change

before entering any further adjustments.

2. On the GHC 10, select

gain adjustments. There are two types of gain settings at both low and high speeds:

•

Rudder Gain—Adjusts how tightly the rudder holds the heading and makes turns. If you set this value too high, the autopilot may be

overactive, attempting to constantly adjust the heading at the slightest deviation. An overactive autopilot can cause excess wear and tear

on the autopilot pump.

•

Counter Gain—Adjusts how tightly the rudder corrects the turn overshoot. If you set this value too high, the autopilot can overshoot the

turn again when attempting to counter the original turn.

EN–

Setup

Dealer Autopilot Configuration

Turn Fine Tuning Setup

ConfigurationNotesfortheGHP™10AutopilotSystem

Rudder Gains

to access the rudder