Alke Global-5-2FSEI Instalasi, Layanan & Petunjuk Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Instalasi, Layanan & Petunjuk Pengguna untuk Pemanas Alke Global-5-2FSEI. Alke Global-5-2FSEI 18 halaman. Atmospheric stainless-steel gas infrared heaters for use in well ventilated areas

Halaman Cetak

Electrical supply:

50/60Hz, IP65

Power:

Current rating:

Waiting time T(w)

Safety time T(s)

30 seconds

Schematic diagram electronic ignition device

The operating or control box, which is not delivered by the manufacturer but by the installer, can be installed

on any desired place and height, provided this is within reach of the user. The temperature sensor shall have

a free view to a heater and placed on a position representative for the average temperature needed in the

whole space. Protect the sensor for draught, direct sunlight or cold walls. Avoid ramping up of the thermostat

by adding a too small temperature differential. It is far more efficient and comfortable not to ignite the

appliance more than 3 times per hour. Try to modulate as much as possible between high and low. To avoid

locking-out, the EID2G control needs to operate at least 3 minutes after each ignition. The drawings below

give a typical lay-out for the position of a switch box or thermostat in the electric lines. The drawing is

applicable for the S, 2FS, Ei, 2FEi, SEi and 2FSEi models

Gas line supply

In case a main gas line supplies the gas to the heaters, make sure that an authorised company in your

country, in accordance with the local rules and requirements, install the system. To avoid problems, use

galvanised or copper tubing for the gas line. First make a calculation to determine the capacity of the

whole system and the diameters of the piping in each section. Use the common available calculation

methods as written in most gas installation standards. Contact an installer or the distributor in case this

calculation method is not available in your area. For data needed to calculate the dimensions of the gas

line, see the technical table on the last page.

The most common way to install a gas line is in the centre of the barn (at least 2-meter-high) with every

3 to 5 meter a "T" or "cross" connection for gas supply to the heaters. Always mount a (easy reachable)

gas tap at the beginning of the gas hose to the heaters. This gas tap is needed to close the gas supply

to the burners to extinguish the flames. In addition, it makes it possible to remove the heaters after use

or to service the heaters safely. The gas inlet at the heater side is standard an 8-mm hose nipple

(optional a smooth hose nipple or a G1/8" right handed thread. Other connections are possible after

consultation). Always use approved gas sealant to close the gas connections.

Version: Sept 2017

230VAC

230VAC 50/60Hz, IP65

24 VAC 50/60Hz, IP65

Max 30VA

Max 0,2A

7 seconds

S (Ceme)

17VA

0,1A/0,9A

Timing diagram electronic ignition device

TH1

TH2

NB: dotted line is optional on

the Ei model (as SEi model)

or only applicable for the S

model (as S or 2FS)

S (Asco)

230VAC 50Hz, IP65

24VAC 50Hz, IP65

6,3W

0,05A/0,3A

To control box

To additional zones

Thermostat on/off

Thermostat high/low

Brown

Blue

Yellow/Green = Earth

Electronic Ignition

Device

Solenoid for high/low

manual number: 0009 0440EN