Garmin GPS 152H Panduan Pemilik - Halaman 20
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem GPS Kelautan Garmin GPS 152H. Garmin GPS 152H 32 halaman. Declaration of conformity
Juga untuk Garmin GPS 152H: Panduan Memulai Cepat (49 halaman), Panduan Petunjuk Instalasi (36 halaman), Informasi Keselamatan Penting (48 halaman), Pernyataan Kesesuaian (6 halaman)
Halaman Cetak
Settings
To automatically scan for a frequency:
1. Select
Garmin DGPS
in the Serial Data Format field.
2. Select
Scan
in the Beacon field. The unit begins scanning.
If it is necessary to restart the scan, press
Restart
Scan.
To manually enter the frequency and bit rate:
1. Select
Garmin DGPS
in the Serial Data Format field.
2. Select
User
in the Beacon field.
3. Enter the desired frequency and bit rate. The Status field
indicates one of the following:
•
Tuning—attempting to tune to the specified frequency and bit
rate.
•
Scanning—automatically scanning through the frequencies
and bit rates.
•
Receiving—receiving DGPS signal and ready for operation.
•
Check Wiring—not making a connection with a DGPS
receiver.
When the unit is receiving a DGPS signal, the SNR (Signal to
Noise Ratio) and Distance fields contain data. The SNR range
is 0dB to 30dB, with 30dB being the best. The Distance field
may or may not show data, depending upon the signal being
broadcast from the DGPS site.
1
Using the Alarms Tab
You can set the unit to sound an audible alarm when certain
conditions are met. By default, all alarms are turned off except the
arrival alarm.
Menu
and select
From any Main page, press
Menu
•
Anchor Drag—sets an alarm to sound when you exceed a
specified drift distance.
•
Arrival—sets an alarm to sound when you are within a
specified distance or time from a destination waypoint. Select
Dist
(distance) or
Time
to set whether the arrival alarm
triggers on distance to arrival or time to arrival.
•
Off Course—sets an alarm to sound when you are off course
by a specified distance.
•
Clock—sets an alarm using the system (GPS) clock. The unit
must be on for the clock alarm to work.
•
Shallow Wtr—sets an alarm to sound when the depth is less
than the specified value.
•
Deep Water—sets an alarm to sound when the depth is
greater than the specified value.
twice and highlight Alrm.
GPS 152H Owner's Manual