Garmin GPS 16-HVS Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem GPS Kelautan Garmin GPS 16-HVS. Garmin GPS 16-HVS 30 halaman. Instruction manual
Juga untuk Garmin GPS 16-HVS: Panduan Referensi (1 halaman), Spesifikasi Teknis (40 halaman), Spesifikasi Teknis (37 halaman), Pernyataan Kesesuaian (2 halaman), Buku Petunjuk (30 halaman)

Halaman Cetak

1. Wiring

Appendix A. CR23X/CR10X Programs

Port Serial I/O (P15)

1: 1

2: 61

3: 1

4: 5

5: 1

6: 0

7: 42

8: 100

9: 80

10: 1

11: 1

12: 0

8: Port Serial I/O (P15)

1: 1

2: 61

3: 1

4: 1

5: 1

6: 0

7: 42

8: 100

9: 80

10: 1

11: 1.0

12: 0.0

A-2

Multiplier, always 1.

Offset, always 0.

P15 parameters 4, 5, and 10 are somewhat variable. When using a CR23X,

parameter 4 can be set to 05, 06 or 07 depending on what control ports are

used. A CR10X can use control ports 1 through 6. Wiring of the

communication cable depends on the selection for parameter 4. With a CR23X

the GPS transmit wire is connected to the control port selected in parameter 4.

With a CR10X, the GPS transmit wire is connected to the control port 1 higher

then the control port listed in parameter 4.

P15 is executed when the PPS signal drives control port 8 high. P15 will wait

until one of three conditions is met: the time-out listed in parameter 9 has

expired, the maximum number of characters in parameter 8 have been read, or

the termination character listed in parameter 7 has been read.

P15 parameter 10 is the first input location you wish to store GPS data in.

Fifteen sequential input locations will be used to store time and position.

Example A-1. Program Instruction 15 (P15) for CR23X

Reps

-- ASCII/RS-232, 1200 Baud, decimal delimiter

Delay (units = 0.01 sec)

Control Ports

Output Loc [ Bulk

]

No. of Locs to Send

Termination Character

Maximum Characters

Time Out Delay (units = 0.01 sec)

Loc [ Raw_time1 ]

Mult

Offset

Example A-2. Program Instruction 15 (P15) for CR10X