Alke Global-8 Series Panduan Pengguna dan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Instalasi untuk Pemanas Alke Global-8 Series. Alke Global-8 Series 17 halaman.

Internal cleaning

The internal part of a heater can be cleaned with compressed air or with a tube brush. If needed do this

every day. First clean the outside of the burner globe. Then the inside of the venturi and burner tube

via the dust filter connection. Repeat this 3 times to be sure the dust is removed.

Water

Never wash the heater with water when it is operating or still hot. Do not clean the heater with steam or

chemicals or high pressure jets. The lifetime of the burner globes will go down in those cases. It is

allowed to wash the inside of the venturi and burner globes with low pressure (warm)water from a normal

hose (so not pressurized) to remove greasy dust. Be sure that the burner is completely dry before using

it again. Also make sure that the gas safety device and injector remains dry all the time.

High fire

The lifetime of infrared heaters in a dusty environment will be extended in case these heaters are

operated on high fire every 12 to 24 hours for minimal 15 minutes. This burns off dust in the burner that

accumulates during low-fire operation. This is only needed in case heaters operate on lower setting for

a longer period. When a barn computer is used for heating and ventilation, it will be easy to modify the

program to add a 15 minutes high fire operation every day. In case a mechanical thermostat TH is used

a solution can be to put the sensor for 15 minutes in a bucket with cold water during daily inspection of

the barn.

Version: April 2016

manual number: 0009 0440EN