Garmin GPSMAP 400 series Panduan Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Sistem GPS Kelautan Garmin GPSMAP 400 series. Garmin GPSMAP 400 series 30 halaman. Non-waas; display interfaces
Juga untuk Garmin GPSMAP 400 series: Petunjuk Manual (6 halaman), Adendum Panduan Pilot (27 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi (2 halaman), Panduan Petunjuk Instalasi (28 halaman), Panduan Templat (2 halaman), Templat (1 halaman), Panduan Konfigurasi (2 halaman), Panduan Pilot (28 halaman), Panduan Referensi Cepat (2 halaman)

3. Install the unit in the opening (see Figure 2):

• Place the unit housing in the recently cut hole in the mounting surface.

• Slide the tension mount arms onto the hex bolts and secure them with the (4) wing nuts.

• Tighten the (4) wing nuts to secure the unit housing to the mounting surface. Be careful not to overtighten.

Assembled unit and

flush mount hardware

NOTE: If you are installing a Fishfinder 400C, the wiring harness must be connected to the boat's power supply and transducer per the installation

instructions included with the unit.

NOTE: If you are installing a GPSMAP 400 series unit, you must connect the wiring harness to the boat's power supply, GPS antenna, XM antenna

(if applicable), and transducer (if applicable) per the installation instructions included with the unit.

Tension mount brackets

Figure 2

Wing nuts