Garmin GPSMAP 400 series Panduan Pilot - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Pilot untuk Sistem GPS Kelautan Garmin GPSMAP 400 series. Garmin GPSMAP 400 series 28 halaman. Non-waas; display interfaces
Juga untuk Garmin GPSMAP 400 series: Petunjuk Manual (6 halaman), Adendum Panduan Pilot (27 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi (2 halaman), Panduan Petunjuk Instalasi (28 halaman), Panduan Petunjuk Instalasi (30 halaman), Panduan Templat (2 halaman), Templat (1 halaman), Panduan Konfigurasi (2 halaman), Panduan Referensi Cepat (2 halaman)

Halaman Cetak
Garmin GPSMAP 400 series Panduan Pilot
SECTION 4
RYAN TCAD INTERFACE

TCAD Setup Page

The Ryan TCAD Setup Page is accessed from the Traffic
Page. The TCAD Setup Page allows traffic data to be
configured. The definitions of the available options are
listed in the TCAD Pilot' s Handbook.
Changing a TCAD setup option:
Turn the small right knob to select the Traffic
1)
Page.
2)
Press the MENU Key to display the Page
Menu.
Turn the small right knob to select 'Setup?'.
3)
4)
Press the ENT Key. The flashing cursor
highlights the Mode field (Figure 4-5).
Figure 4-5 Ryan TCAD Setup Page
5)
Turn the small right knob to select the desired
mode. The mode selection determines which
shield definition to display and change.
Press the ENT Key.
6)
7)
Select the desired remaining options fields
by turning the large right knob, then turn
the small right knob to select the desired
option, and press the ENT Key to confirm the
selection.
8)
Return to the Traffic Page by pressing the CLR
Key.
4-4
Traffic Page Fields
There are two selectable fields on the Traffic Page:
the Operating Mode Field and the Barometric Pressure
Field. The Operating Mode Field selects the TCAD
operating mode (Table 4-2). Please, refer to the TCAD
Pilot' s Handbook for a complete description of all modes
of operation. For the 9900BX model, this field is replaced
with the SKYWATCH style altitude mode.
NOTE: The modes APR (approach) and DEP
(departure), are displayed when in either of those
modes, but are not manually selectable.
400/500 Series Display Interfaces
TCAD 9900B Operating Modes
GND
Ground Mode
TML
Terminal Mode
STD
Standard Mode
ENR
Enroute Mode
UNR
Unrestricted Mode
Table 4-2
190-00140-10 Rev. E