AEG NC7003000 Panduan Pengguna - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven AEG NC7003000. AEG NC7003000 36 halaman. Oven
Juga untuk AEG NC7003000: Panduan Pengguna (36 halaman)

Halaman Cetak

26 www.aeg.com

12. WHAT TO DO IF...

WARNING!

Refer to the Safety chapters.

The oven does not heat

The oven lamp does not

operate

The display shows an er-

ror code that is not in

this list

If you cannot find a solution to the prob-

lem yourself, contact your dealer or the

service centre.

The necessary data for the service centre

is on the rating plate. The rating plate is

Problem

Pull the door trim to the front to re-

move it.

Hold the door glass panels on their

top edge one by one and pull them

upwards from the guide.

Clean the door glass panels.

To install panels do the above steps

in the opposite sequence. Insert the

smaller panel first, and then the

larger one.

Possible cause

The appliance is switch-

ed off

The clock is not set

The necessary settings

are not set

The automatic cut-out is

switched on

The fuse is released

The oven lamp is defec-

tive

There is an electronic

fault

on the front frame of the appliance cavi-

ty.

Solution

Switch on the appliance

Set the clock. Refer to

"Setting the clock"

Make sure, the settings

are correct

Refer to "Automatic cut-

out"

Make sure, if the fuse is

the cause for the mal-

function. If the fuse re-

leases again and again,

refer to an authorized

electrician

Replace the oven lamp

• Switch off the appli-

ance with the house

fuse or the safety

switch in the fuse box

and switch it on again

• If the display shows

the error code again,

refer to the Customer

Care Department