Garmin GPSMAP 700 Series Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Sistem GPS Kelautan Garmin GPSMAP 700 Series. Garmin GPSMAP 700 Series 10 halaman. Flat-mount kit
Juga untuk Garmin GPSMAP 700 Series: Panduan Referensi Cepat (2 halaman), Panduan Konfigurasi (2 halaman), Templat (2 halaman), Panduan Memulai Cepat (4 halaman), Panduan Pemilik (38 halaman), Panduan Pemilik (44 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Pemilik (50 halaman), Panduan Petunjuk Instalasi (34 halaman)

Identifying the Rear-Panel Connectors

After the power/data cable is wired to the boat (and after any optional Garmin radar, NMEA 0183, NMEA 2000, or external GPS devices are

installed) connect the cables to the GPSMAP 700 series chartplotter.

NOTE: You must install the locking rings before connecting the power/data cable or a Garmin radar cable to the chartplotter

to connect a cable to the back of a GPSMAP 700 series chartplotter:

1. Carefully press the cable into the correct port on the back of the chartplotter until it is firmly seated. Do not force the cable, because this

may damage the pins.

2. After the cable is seated, turn the locking ring clockwise until it is tight. Be careful not to overtighten the locking ring.

updating the Chartplotter Software

The GPSMAP 700 series chartplotter may contain a software update SD card. If so, follow the instructions provided with the card.

If a software update SD card is not included, visit

version of software on your chartplotter, select or touch

GPSMAP 700 Series Installation Instructions

➋

➊

GPSMAP 700 Series Connectors

➊

NMEA 2000 connector

➋

Radar port

➌

Power/data connector

➍

External GPS antenna connector

www.garmin.com

Configure

➌

➍

to make sure your chartplotter software is up-to-date. To identify the

System

System Information.

(page

4).